您要查找的是不是：
- compensating unbalance load current 不平衡负载电流补偿
- unbalanced load current 不平衡负载
- Unbalanced loads do not carry easily. 不平衡的货物不容易运输
- Load current is set in 1.56% increments of the maximum value. 负载电流在最大值增量的1.;56%25中设置。
- Moisture proof and no contact output, Load current 1A max. 具防潮功能并且采用无接点方式，限时控制负载电流最大1A.
- When ordering overload relays, specify horsepower, voltage and full load current per motor nameplate. 订购过载继电器时，请注明每台电机的功率马力、电压和满载电流。
- Simulation and experiment show the UPS system has the merits of strong ability with three-phase unbalanced load,low total harmonic distortion(THD) of output voltage,high work efficiency. 通过仿真和实验结果表明,该UPS系统具有带三相不对称负载能力强,输出电压波形总谐波失真度(THD)小,工作效率高等优点。
- The load current is handled directly by the controller through semiconductor switching devices. 负荷电流由调节器通过半导体开关元件直接控制。
- The peak load current limit is set by the user's selection of a reference voltage and current-sensing resistors. 用户可通过选择参考电压和电流感测电阻设置峰值载荷电流限制。
- An "Overcurrent Relay" is a type of protective relay which operates when the load current exceeds a preset value. 过电流继电器是继电保护装置的一种，当负载电流超过整定值时，继电器动作。
- Choosing the load current phasor as the reference for the phasor diagram analysis is straightforward and effective. 以负载电流相量为参考的新的相量图分析方法是简洁有效的；
- The current distribution in fuses is discussed when high frequency components are present in the load current. 还讨论了在负载电流中引入高频分量时熔断器中的电流分布问题。
- three-phase unbalanced load flow 三相不平衡潮流
- Consequently, no load current flows through R6 because Q2, whose base-emitter voltage is now 0V, has turned off. 由于Q2的基极-发射极的电压为0V而截止，因此没有负载电流流过R6。
- shallow cover and unbalanced load of passenger 浅埋偏压
- load compensation of unbalanced load 不平衡负荷补偿
- In the test for voltage regulator, the load current of the DUT provided by the test equipment needs a certain delaytime to reach the provision value. 在电压调整器测试中,测试设备提供的负载电流需经一定的时间延迟才能达到预定值。
- Synchronous rectification circuitry allows the load current to flow through the low RDS(on) of the DMOS output driver during current decay. 同步整流电路允许负载电流在电流衰减过程中通过DMOS输出驱动器的低RDS(on)流动。
- The desired load current level is set via the serial port with two six bit linear DACs in conjunction with a reference voltage. 可通过有两个6位线性DAC串行接口及参考电压来设置期望的负载电流电平。
