您要查找的是不是：
- yield shear stress 屈服剪应力
- Critical resolved shear stress (O’crss). 临界分剪切应力。
- Oxygen precipitates (useful for gettering) can reduce the yield strength (critical shear stress) up to fivefole. 氧沉淀(可用作吸杂)会使屈服强度(临界剪应力)降低为五分之一。
- Oxgen precipitates (useful for gettering) can reduce the yield strength (critical shear stress) up to fivefole. 氧沉淀（可用作吸杂）会使屈服强度（临界剪应力）降低为五分之一。
- Otherwise, the pastes with wide particle distribution have higher yield stress, lower dieland wall shear stress, and paste was easily extruded. 粒度分布较宽的含有细碳化硅的挤压物料具有高的屈服值和低的滑移膜初始剪切应力,使物料在模段内容易实现挤出。
- The yield conditions of axisymmetric circular plate and shallow spherical shell of reinforced concrete based on Twin shear stress yield criterion are presented in the paper. 导出了基于双剪屈服准则的钢筋混凝土球扁壳的屈服条件,并利用此屈服条件求解出其极限荷载。
- The interfacial shear stress is a constant proportion of the bottom shear. 交界面的剪力与底部剪力之比是常数。
- The process does not affect the shear stresses. 这样的处理并不影响剪应力。
- According to the twin shear stress theory, this paper improves on Duncan Model. 根据双剪应力理论对邓肯模型进行了修正。
- Tensile stress and shear stress are transferred by PBL shear connectors. 计算得到钠-混凝土接头的最不利荷载组合内力。
- A fluid is a substance that deforms continuously under an applied shear stress. 液体在剪应力作用下不断变形？？
- The main shear stress and its hydraulic system, calculation and research. 主要对其剪切力和液压系统进行计算和研究。
- The design curves of equivalent damping ratio to the brace stiffness,and ratio of maximum damping force of the damping device to the inter-story yield shear force of the structure are proposed. 本文就消能减震结构设计参数,即消能部件的支撑刚度、层间最大阻尼力与结构层间屈服力比值等恢复力模型参数的选取进行了讨论。
- Thus fluid shear stress has been considered one of the atherogenic factors. 在动物研究中还发现切应力与内皮细胞增生程度有关。
- With gob span increasing, equivalent shear stress in basic roof increases. 随着采空区跨度的不断增加，基本顶等效剪力不断增大。
- Draw the element for maximum shear stress and mark values of all stresses. 画出最大剪应力的单元体并标出全部应力值。
- Friction and cohesion are best defined in terms of the plot of shear stress versus normal stress given in Figure 9. 摩擦角和粘结力最好是根据图9中剪切应力和法向应力的关系曲线确定。
- Cohesion is best defined in terms of the plot of shear stress versus normal stress given in Figure 9. 粘结力最好根据图9中剪切应力和法向应力的关系曲线确定。
- The occurrence of high shear stress at the fibre end is a factor which is expected to lead to crack generation. 在纤维端部存在高切变应力视为导致产生裂缝的因素。
- Twin shear stress yield criterion 双剪应力屈服模型
