您要查找的是不是：
- The results show that the system runs steadily when the driving flow mass flow rate equals to the diffuser outlet vapor flow mass flow rate. 结果表明，当工作流流量同扩压段出口蒸气流量相等时系统能够稳定运行。
- vapor flow rate 通风流量
- Consistent flow rate from nebulizer to nebulizer. 在雾化器间提供持续稳定的流通速率。
- Affect the melt flow rate and the cooling speed. 会影响熔体的流动性和冷却速度。
- Possibility to control the flow rate by Pump. 由蠕动泵调节盐溶流量。
- Typical maximum system flow rate (7.5 feet/sec. 标准最大系统流量为7.;5英尺/秒。
- The HTA flow rate has two-faced influences on them. 热风流量对其影响呈现两面性。
- Insufficient or excessive vapor flow detected during evaporative emission system operation. 在蒸汽散发系统运转过程中，检测到气流量不足或过多。
- Either flow rate is insufficient or CPU is overoccupied. 不是流量不够用就是CPU资源占用过多!
- All models pass a full 360 degree rollover test without fuel leakagTo accomplish this, fuel and vapor flow controls are required for all fuel tank connections. 所有车型均经过了完全360度翻滚测试而没有燃油泄漏。为实现这一点，所有的油箱连接处都需要燃油和蒸汽流量控制。
- Detection wavelength was 260 nm,flow rate 0.7 mL/min. 检测波长2 6 0nm ; 流速为 0 .;7mL/min。
- How the Catering Enterprises Face a High Employee Flow Rate? 员工流动率高餐饮企业如何面对?
- Average flow rate (AFR) adds from 3.42ml/s to 9.89 ml/s. 平均尿流率(AFR)从3 .;4ml/s增至9
- Turn on the carrier gas, and establish the proper flow rate. 接通载气，调至合适地流速。
- Decreasing the gas flow rate leads to pressure undershoot. 气量突降时，膨胀波沿程传播。
- Effect of absorbent flow rate on CO2 absorption is unobvious. 吸收剂流量对CO2吸收过程没有明显的影响。
- The vapor heat capacities as a function of temperature at 101. 3kPa of three binary systems, acetone-chloroform, benzene - carbon tetrachloride and benzene-ethanol, were measured in a multicomponent vapor flow calorimeter constructed in this laboratory. 用自行建立的多组分气体流动热量计测定丙酮-氯仿、苯-四氯化碳和苯-乙醇3个二元体系于不同温度、不同组成时的常压汽相热容。
- Read horizontally to flow rate curve and vertically downward to flow rate gpm. 读出水平线上的流量曲线和垂直线下方的的流量（加仑/分钟）。
- The test is designed to determine the flow rate of the reactor coolant pump. 试验是设计用来确定反应堆冷冻剂泵的流速。
- Low flow rate and high temperature tends to favorto elution process. 高速低温有利于吸附,低速高温有利于洗脱;
