您要查找的是不是：
- The transformer winding should be impregnated with insulation paint and baked. 变压器绕组要用绝缘漆浸透并烘干。
- Be suitable for coil winding of stator winding and transformer winding which need wire arrangement. 适用定子线圈,变压器线圈需排线的线圈绕制。
- The factors that cause the resistance unbalance of transformer winding are summarized and analysed. 综述了引起变压器绕组电阻不平衡的因素，并进行了分析。
- The method to check short-circuit point between parallel conductors in transformer winding by Gaussmeter and to repair fault point are introduced. 摘要介绍了运用高斯计来探查变压器绕组内并联导线间短路点，并对故障点进行修复的方法。
- The economical repacking plan is put forward to suit transformer winding connection and to reduce the effect on smelting. 提出适应变压器绕组接线组别,减小对电炉冶炼影响的比较经济的改装方案;
- The effect of tap changer on transformer winding resistance measurement is discribed.Some suggestions on the measurement are made. 叙述了分接开关对变压器绕组电阻测量的影响，并对该项测量提出了一些建议。
- The Feasibility of estimaing transformer winding deformation by measuring short-circuit reactance is analysedin detail in this paper. 本文通过理论分析,证明可以利用短路电抗实现对变压器绕组变形的在线监测。
- Moreover, a new analytical model for the transformer winding loss in flyback converter is also proposed by utilizing the orthogonality of the two field components. 通过研究其线圈窗口磁场的正交性，进一步提出一种新型反激变换器的变压器线圈损耗解析模型。
- WANG Yu,XU Da-ke,LI Yan-ming.A study on instrumentation techniques in LVI method for detecting transformer winding[J].High Voltage Engineering,1998,24(3):24-28. [4]王钰;徐大可;李彦明.;检测变压器绕组变形的低压脉冲法测试系统研究[J]
- The measurement and calculation of radio capacitance of power transformer winding are introduced based on example. The correction coefficient in design and calculation is presented. 摘要通过实例介绍了电力变压器绕组径向几何电容的测量及估算，提出了在设计估算中引入修正系数。
- In view of complex nature of the stiffness and damping of large power transformer winding, a new method used to modify the stiffness and damping coefficients of large power transformer winding is presented in this paper. 摘要鉴于变压器绕组刚度及阻尼特性的复杂性，提出了一种确定变压器绕组刚度系数的新方法。
- The main circuit topology of three phase DVR is analyzed,the design method of the parameters of the main circuit is presented and different ways of transformer winding connection are compared. 针对以往研究的三相动态电压恢复器,提出基于三相电压型逆变电路的动态电压恢复器,并分析其主电路拓扑,提出主电路几项参数的设计方法,同时对比不同变压器接法对参数和电路性能的影响。
- The transformation of mode voltages and mode currents is applied in order to obtain MTL general solution, and the transfer functions of transformer winding are obtained. 采用模电压、模电流变换实现了模型多导体传输线方程的通用性解耦,结合绕组的结构和首末端条件计算了绕组不同位置的传输函数。
- The wind was whispering in the trees. 一阵风穿过树林沙沙作响。
- Welding principle and its operating process of flat copper wire in large transformer windings are introduced. 介绍了大型变压器绕组用扁铜导线的焊接原理及其操作工艺。
- The wind whirled the dead leaves about. 风吹得枯叶在四处回旋。
- The boat heeled over in a strong wind. 船在强风吹袭下倾侧了。
- The shutters thumped the wall in the wind. 在风中百叶窗砰砰地碰在墙上。
- The relation between transformer windings under different axial precompression and the vibration of transformer walls is studied. 摘要研究了变压器绕组预紧力与变压器箱壁振动之间的关系。
- It performs an extensive and in depth research theoretically and methodologically on this topic, the deformation of transformer windings. 从原理和方法上对变压器绕组变形这一课题进行了广泛深入的研究。
