您要查找的是不是：
- internal tooth lock washer 内齿锁紧垫圈
- Countersunk external toothed lock washer for assembly 组合件用锥形锁紧垫圈
- tooth lock washer 齿锁紧垫圈
- Countersunk serrated external toothed lock washers 锥形锯齿锁紧垫圈
- Early lock washer on left, as used on the 600 series. 左边是早期的固定垫圈，使用在600系列上。
- toothed lock washer 齿式锁紧垫圈
- To replace diaphragm; loosen lock nut (48) and remove lock washer (46), diaphragm plate (60) and diaphragm (20). 要更换隔膜，先松开锁紧螺母(48)，并拆卸锁紧垫圈(46)，隔膜板(60)和隔膜(20)。
- Hold stem (27) on wrench flats and remove nut (51), lock washer (46), diaphragm plate (60) and diaphragm. 在扳手的平面上握住阀杆(27)并拆卸螺母(51)，锁紧垫圈(46)，隔膜板(60)和隔膜。
- Loosen and remove the diaphragm lock nut and lock washer, pressure plate and diaphragm from the valve stem. 松开和拆卸隔膜锁紧螺母和锁紧垫圈，从阀杆上往下压阀盘和隔膜。
- Disassemble module. Use wrench to loosen stem nut and remove lock washer and diaphragm plate. Remove yoke by loosening disc holder using a screw driver. 拆卸模块。使用扳手松开阀杆螺母，并且拆卸锁紧垫圈和隔膜板。采用螺丝刀，通过松开阀瓣支架来拆卸轭架。
- Smaller sizes use a lock nut with a locking washer (a), larger sizes use a nut with locking clip (b). 小尺寸轴承使用带锁紧垫圈的锁紧螺母(a)大尺寸的轴承使用带锁紧卡箍的锁紧螺母(b)。
- Her teeth locked together in anger. 她气得咬紧牙关。
- His teeth locked together in anger. 他气得咬牙切齿。
- Single coil spring lock washer for assembly 组合件用弹簧垫圈
- lock washer with tongue at outside 外舌止动垫圈
- Hangzhou Zhengda Spring Lock Washer Co., Ltd 杭州正大弹簧垫圈有限公司
- Serrated lock washer external teeth for assembly 组合件用外锯齿锁紧垫圈
- front wheel bearing nut lock washer 前轮毂轴承螺帽锁紧垫圈
- I was given gas when they pulled my tooth out. 给我拔牙时用了一氧化二氮。
- lock washer with tongue at inside 内舌止动垫圈
