您要查找的是不是：
- The temperature increases by leaps and bounds. 温度很快就升高了。
- If the temperature increases, the ice melts. 温度上升时; 冰就融化（melt）.
- With the temperature increasing, the ultrafiltration membrane flux increased. 随着温度的升高,膜通量增加。
- Countermeasures for rapid temperature increasing at No. 6 blast furnace bottom in An-yang Iron and Steel Co. 安钢6号高炉炉底温度急剧上升的处理。
- Zn grains grew gradually and its morphology transformed from graininess to lamellae with the temperature increasing. 随浸锌温度的升高，锌晶粒逐渐长大，并由粒状转变为片状。
- The liquidus temperature increases with increasing Ag % of the solder. 合金之液相线温度随银含量增加而提高。
- As the temperature increases,the volume of water becomes greater. 温度增高，水的体积就增大。
- As the temperature increase, the volume of water becomes greater. 温度增高,水的体积就增大。
- As the temperature increases, the volume of water becomes greater. 温度增高，水的体积就增大。
- However, the alumina layers spall as the temperature increases. 但是，氧化铝层剥落的温度升高。
- When the temperature increases, the mesopore volume decreases. 随着调制温度的继续提高，中孔含量下降；
- The body's temperature increases and perspiration fails. 身体的温度就会升高同时不能够排汗。
- Hall effect measurement show that the resistivities of CdTe thin film monotonously decreased with the temperature increasing. Hall效应测试表明，CdTe多晶薄膜的电阻率随着温度的升高呈单一下降趋势。
- W5+ is a mediate species during sulfidizing process, which can be transferred to W4+ with sulfidizing temperature increasing. 在催化剂硫化过程中，W5+是硫化过程中的一种中间过渡产物，随硫化温度的升高可转化为W4+。
- The results show after heating, the emanation coefficient of Rn in above materials decreases gradually according to the heating temperature increasing. 实验结果表明,上述地质材料的氡射气析出率随灼烧温度升高而减小。
- First, the damage accumulates at the boundary, then it spreads toward the cements.The damage occurred at temperature increasing. 研究结果表明：混凝土内界面是最薄弱的环节，损伤首先在界面上发生，然后向水泥砂浆中发展；
- The potential of chlorine evolution and anodic potential decrease with the temperature increasing,and it is beneficial to chlorine evolution. 温度升高,析氯电位和阳极电极电位降低,有利于氯气的析出。
- It is considered that the microcracks are apt to form on the dendritic interfaces with temperature increasing, as leads to plasticity decreasing. 随着温度的升高，沿枝晶界面易于形成显微裂纹，导致塑性降低。
- A good insulation around the cement favours an temperature increase. 水泥周围的良绝热体又有利于温度的增高。
- With annealing temperature increasing, diffuse precipitated phases Al6(Fe,Mn) and Al(Fe,Mn) act on particle stimulate nucleation during process of re-crystallization . 随着退火温度的升高,第二相粒子Al6(Fe,Mn)和Al(Fe,Mn)Si在再结晶过程中起到了粒子促进形核作用(PSN)。
