您要查找的是不是：
- temperature increase emulation 温升仿真
- As the temperature increase, the volume of water becomes greater. 温度增高,水的体积就增大。
- A good insulation around the cement favours an temperature increase. 水泥周围的良绝热体又有利于温度的增高。
- The temperature increases by leaps and bounds. 温度很快就升高了。
- If the temperature increases, the ice melts. 温度上升时; 冰就融化（melt）.
- The level of cementation behind the casing is in general clearly marked by a distinct temperature increase. 套管外水泥面通常能够清楚地被明显的温升标志出来。
- In these bearings, the initial friction is also much lower, so that temperature increase is almost negligible. 这类轴承的初始摩擦非常低,因此温度的上升几乎可以忽略。
- As the temperature increases,the volume of water becomes greater. 温度增高，水的体积就增大。
- The reduction of snow area was mainly effected by continually temperature increase and changeful precipitation. 持续的增温与不稳定的降水量是造成研究区的冰雪面积持续减小的主要原因；
- However, arc temperature increase with thermit mixture increase in coating because of its great chemical heat effect. 焊条药皮中加入铝热剂,其反应生成的化学热效果明显,使水下焊接电弧的温度有显著升高。
- As the temperature increases, the volume of water becomes greater. 温度增高，水的体积就增大。
- However, the alumina layers spall as the temperature increases. 但是，氧化铝层剥落的温度升高。
- When the temperature increases, the mesopore volume decreases. 随着调制温度的继续提高，中孔含量下降；
- The body's temperature increases and perspiration fails. 身体的温度就会升高同时不能够排汗。
- As the reduction temperature increase,the migration reac-tion between V,Ti and Si can be remarkably promoted. 提高还原反应温度可明显地增进钒、钛、硅间迁移反应的进行。
- The catal yst with the same support showed similar temperature increase and selectivity. 结果表明,采用相同载体催化剂的升温特性和选择性相似。
- Officials from more than100 countries say the world must act immediately to cap the global temperature increase at two degrees Celsius. 来自100多个国家的官员说，全世界必须立即行动，将全球升温控制在2摄氏度以内。
- The heating elements were installed at the rear side of the working chamber. Forced horizontal air circulation. Fast temperature increase. 加热器按装在工作室背部,水平强迫对流,升温快。
- Normally we add 10 W/ m2 extra installed power in order to achieve a faster temperature increase from economy to comfort level. 为使经济温度快速升高到舒适温度，通常情况下我们把每平米增加10瓦的能量。
- During extrusion of PP, die pressure and apparent viscosity prominently decrease, and die temperature increase with ultrasonic treatment. 超声辐照使PP挤出过程中的口模压力、表观粘度显著下降，熔体指数增大，提高挤出产量达100%25。 超声挤出PP口模温升达10℃以上，降低了挤出物的出口膨胀率，挤出物表观质量有所提高。
