您要查找的是不是：
- Experimental Study of the Wet Steam Flow Field in LP Steam Turbine 汽轮机内湿蒸汽两相流流场的实验研究
- THE INFLUENCE OF STEAM FLOW FIELD AT CONDENSER'S TUBE - BUNDLE INLET UPON EXHAUST PRESSURE OF STEAM TURBINE 凝汽器管束入口蒸汽流场对汽轮机排汽压力的影响
- The simulation of the steam flow field and heat transfer performance in condenser of a 600 MW steam turbine 600MW机组凝汽器汽侧流动与传热性能模拟
- NUMERICAL PREDICTION AND IMPROVEMENT OF THE THREE DIMENSIONAL STEAM FLOW FIELD AND HEAT TRANSFER BEHAVIOR OF A POWER PLANT CONDENSER 凝汽器三维汽相流场与传热特性的数值预测及改善
- steam flow field 蒸汽流场
- The teeming time and height affect flow field too. 并分析了流体注入时间、注入高度对流场的影响。
- Realized the two dimensional flow field of steam ejector by the method of CFD numerical simulation,and discussed the maneuvering condition of ejector. 用CFD数值模拟的方法实现了蒸汽喷射器二维流场的分布和变工况特性。
- Error: gui-monitor-residuals: Uninitialized flow field. 直译就是流场没有初始化！！！！重新初始化。
- Fluid pressure signal validates result of flow field computation. 液体压力信号验证流场建模与计算的结果。
- The steam turbines are designed to handle required large volume steam flow due to low pressure and temperature. 汽轮机设计为适用于因低压力低温度而需要的大流量汽流。
- The relation between main steam flow and spray desuperheating water flow was derived by using differential theory. 利用微分理论，得出主蒸汽流量同减温水流量间的依变关系。
- Is there any difference between the steam flow at MCR condition and at capability condition? 最大连续功率工况下和能力工况下的蒸汽流量有不同吗？
- No. The steam flow at MCR condition is the same as that at the capability condition flow. 不，最大连续功率工况下和能力工况下蒸汽流量相同。
- The research was made on the afterbody flow field of civil aircraft. 本文运用计算与实验相结合的研究方法对民机机身后体流场进行了研究。
- The position of the bottom blown nozzles will influence the flow field d... 在吹气量一定的情况下,底吹喷嘴位置对流场有较大影响。
- James Watt's flyball governor (1769) regulated steam flow to a steam engine to maintain constant engine speed despite a changing load. 1769年瓦特的飞球调速器,它是一种调节蒸汽流的装置,即使荷载变化仍可保持蒸汽机的转速不变。
- The typical seepage flow field of the bottom for the spillway dam is obtai... 最后计算了典型的坝基渗流流场,计算结果与实验结果吻合较好。
- Experimental Study on Image Preprocessing of Thermal Flow Field Tomogram[J]. 引用该论文 姚卫;闫大鹏;王振东;尤海航;贺安之.
- The cause of thermal deviation of boiler superheater was analyzed in this paper.The method of installing steam flow controller was introduced. 分析了锅炉过热器产生热偏差的原因,介绍了采用在炉外管中加装流量控制器的方案和计算过程。
- A whole range of primary temperature and pressurizer level is studied during stretch-out operation.The CATIA2 code is used to analyze a loss of main steam flow accident. 在一次侧平均温度和稳压器水位的整个变化范围内,应用CATIA2程序,对大亚湾18个月燃料循环延伸运行中的主蒸汽流量全部丧失事故进行分析计算。
