您要查找的是不是：
- statistical tolerance limits 统计容许极限
- statistical tolerance limit 统计容许极限
- Stricter acceptable tolerance limit values for customers/sales. 加严的顾客/销售接受容差限值。
- statistic tolerance limits 统计容许极限
- The compaction forces of the other punches are within the tolerance limits. 其他冲杆压力在偏差范围内。
- The compaction force of the prepared punch exceeds the tolerance limit plus. 标记冲杆压力正偏差超过允许范围。
- Adjust the tolerance limits of the main pressure in such a way that the pressure of the prepared punch lies within the tolerance limits. 调整主压力的允许范围,这时准备好的冲杆压力应在允许范围内。
- This test checks whether the monitoring of the compaction force works in case of an infringement of the tolerance limits. 这个测试是检测假设监控压力超过公差范围是否起作用。
- The compaction force of the prepared punch is lying outside the tolerance limit plus. 标记冲杆压力在正偏差之外。
- Ensure with each setting that the compaction force of the prepared punch exceeds the tolerance limit plus. 确保每个标记的压片冲杆的压力设定超过压力正偏差。
- Using statistical tolerance to improve fit quality 应用统计公差提高配合质量
- Pay attention that the main pressure set value does not exceed the tolerance limit plus. 注意主压力设定值不能超过正公差。
- Pay attention that the main pressure set value does not fall below the tolerance limit plus. 注意主压力设定值不能低于正公差范围。
- "Are there tools and procedures with tolerance limits in place for front-to-back registration verification during the artwork setup? Is it identified as a critical SPC parameter? 在底片设计阶段，是否确认了前后对准度的工具/制程最大公差？是否被定义为关键SPC参数？"
- Objective To study the tolerance limit of crewman's arms to windblast with and without protective devices. 摘要目的研究人上肢有／无防护时耐受高速气流吹袭限值；
- Objective To study the tolerance limit of crewman s arms to windblast with and without protective devices. 目的研究人上肢有／无防护时耐受高速气流吹袭限值；为防护装置的设计要求提供试验依据。
- The tablet press is running in set up mode and the compaction force of the prepared punch is still lying outside the tolerance limit plus. 片剂按设定模式运行,标记冲杆压力在正公差之外。
- Convolution method in statistical tolerance analysis 统计公差分析的卷积算法
- Start the tablet press and ensure that the compaction force of the prepared punch still exceeds the tolerance limit plus. 启动压片,确保标记冲杆压力在正公差之外。
- Statistical tolerance design based on selective assembly method 基于选配法的统计公差设计
