您要查找的是不是：
- side air inlet louver 进气用侧百叶窗
- After being improved, both the air inlet louver and outlet louver are bored by jigging just once, which not only improves effectiveness but also guarantees machining hole sizes. 改进后，采用一次装夹，同时对进气和排气孔进行镗加工，提高了加工效率。
- top air inlet louver 上部进气百叶窗
- RAM AIR INLET MECHANICAL LINKAGE. 冲压空气进口机械连杆机构。
- Next, let's make the simple panel under the air inlet that we can find on the side. 接下来，让我们作一个简单小组根据空气进说，我们能够找到对的一面。
- Remove the air inlet hose from the throttle body and air cleaner. 从节流阀体和空气滤清器上拆下气流入口软管。
- Turn off supply pressure and observe float drop to open air inlet. 关闭供应压力,观察浮子下降,因此开启空气进口。
- Check found birdstrike on radome and R engine air inlet. 雷达罩和右发进气道口有鸟击痕迹。
- Air inlet throttle valve with pneumatic actuator and positioner. 空气进气节流调节阀：带有气动定位和执行机构。
- Connect the air inlet hose to the throttle body and the air cleaner. 将空气入口软管接至节流阀体和空气滤清器。
- air inlet louvers 进气百叶窗,进气孔
- Amongst some of the details outlined in the application are spark plug placement, side air intake, and side exhaust. 其中的一些细节中所概述的应用火花塞安置，侧面进气口，和侧面排气。
- Safety equipment is sufficient with dual front airbag and side air bag.It has EBD and ABS and traction control. 安全设备充足，如双前气袋及车侧气袋，它亦有电子制动分配系统、防杀车锁死装置及牵引控制装置等。
- Slowly open vent needle valve just as air inlet opens. Record differential pressure. 当空气进口开启时,慢慢开启排气针形阀。记录压差。
- As you can see, the new model looks very different to the current car with a pair of sweeping side air vents, which have been enlarged to cool the improved engine and brakes. 正如你所看到的，新的模型看上去非常不同，目前的汽车，以方对清扫的通风口，并已扩大到凉爽的改进发动机和刹车。
- Slowly open needle valve "C" bypass (yellow) just as air inlet opens. Record differential pressure. 正当空气进口打开时，慢慢开启针形阀“C”旁路（黄）。记录压差。
- Separation of the water supply from the air inlet is accomplished by means of a diaphragm seal. 供水与空气的隔离是通过采用隔膜密封的方法实现的。
- Separation of the water supply from the air inlet is accomplished by means of a diaphragm seal . 水供应与空气进口的分离通过隔膜密封的方法实现。
- Requirement: Air inlet must start to open when supply pressure is 1.0 PSI or above. Air inlet must be fully open when supply pressure is atmospheric. 要求：当供应压力达到或超过1.;0PSI时，空气进口必须开始打开。当供应压力达到大气压力时，空气进口必须完全打开。
- The valve shall be constructed with a molded diaphragm separating the air inlet from the potable water supply to prevent spillage. 这种阀门应该配置一个模压隔膜，将空气进口与饮用水供水管道隔离开来，以防止泄漏或溢出。
