您要查找的是不是：
- Most safety standards use the 2U -11000 V formula as the basis for testing basic insulation, where U is the operating rms voltage. 大部分安全标准对测试基本绝缘采用2U+1000伏作为基本公式，U为运行电压的均方根值。
- This is the maximum continuous sinusoidal rms voltage, which maybe applied at any temperature upto the maximum operating temperature of the device. 在规定的环境条件下，保证压敏电阻器正常工作所允许连续施加的最大交流电压值。
- For a transformer type ballast, the voltage value to be applied from this table is the rms voltage rating of the capacitor as specified on the ballast. 对于一个变压器型的（传统）镇流器，本表中所列出的电压值是镇流器上标注的电容器的额定电压有效值。
- AC Peak-to-Peak and RMS Voltage Meter 交流峰峰值与有效值电压表
- Average RMS voltage per phase L-N L-N 相的平均均方根电压
- BASED ON SAMPLED AND CALCULATED METHOD TO MEASURE ULTRA-LOW FREQUENCY RMS VOLTAGE 采样计算法的甚低频真有效值电压测量
- Its voltage has not been exceeded. 它的电压没有超过。
- RT RMS voltage power phase L-N 每相L-N实时平均均方根电压
- Rms algorithm and FFT algorithm have been achieved. 实现了均方根算法和FFT算法。
- rms voltage [电] 均方根电压
- Calculation of rms in various waveforms. 各种波形的有效值换算关系
- RMS is a fundamental measurement of an ac signal. 有效值(RMS)是对交流信号的一项基本测量。
- Stuffing box finish to 63 RMS or better. 填料箱抛光度达到63RMS以上。
- Note the polarity of the voltage drop across R. 注意R上电压降的极性。
- The yearly averaged rms width is 4.47km. 全年平均Na层均方根宽度为4.;47km
- Ground and lapped to 2 RMS finish after weld-in. 焊接装配后，进行研磨，抛光精度达到2RMS。
- It is fed into the grid at this voltage. 它是以这种电压馈入电力网。
- The current lags behind the voltage. 电流滞后于电压。
- To apply a small voltage to(a grid). 向栅极加偏压
- That is how voltage is measured. 那就是测量电压的方法。
