您要查找的是不是：
- The value entered for the refresh rate is invalid. 输入的刷新率数值无效。
- Refresh rate value must be between 40 and 120. 刷新率数值必须介于40和120之间。
- Maximum refresh rate of the video controller in Hertz. 该视频控制器的以赫兹表示的最大刷新速率。
- "Minimum refresh rate of the video controller in Hertz. "该视频控制器的以赫兹表示的最小刷新速率。
- The refresh rate must be greater than or equal to 1. 刷新率必须大于或等于1。
- You should select a refresh rate of at least 75 Hertz. 应该选择最少75赫兹的刷新频率。
- Addresses some issues with Vsync and refresh rate problems. 修正某些垂直同步与萤幕更新率的问题。
- Note: for typical displays, flicker occurs at a refresh rate of40 Hz or less. 注：典型的显示器出现闪烁现象是在刷新率为40赫兹或更低时。
- Select the highest or higher screan refresh rate to protect your eye. 选监视器卡片,选择最高或较高的屏幕刷新频率已保护你的眼睛。
- Refresh rate is set by default to the lowest available within the Configuration Tool. 使用设置工具可以设置默认刷新速率。
- Windows chooses the best display settings, including screen resolution, refresh rate, and color, based on your monitor. Windows根据监视器选择最佳的显示设置,包括屏幕分辨率、刷新频率和颜色。
- For more information, see Change screen resolution and Correct monitor flicker (refresh rate). 有关详细信息,请参阅更改屏幕分辨率和正确的监视器闪烁(刷新率)。
- If the refresh rate is too low, the monitor can flicker, which can cause eye strain and headaches. 如果刷新频率太低,监视器可能闪烁,这会引起眼睛疲劳和头痛。
- Click the Monitor tab, and then click the screen refresh rate that you want to use. 单击监视器选项卡,然后单击要使用的屏幕刷新频率。
- This step-by-step article describes how to adjust the refresh rate of your monitor in Windows XP. 本文逐步介绍了如何在Windows XP中调整监视器的刷新频率。
- Starts Windows using your current video driver and using low resolution and refresh rate settings. 启动使用当前视频驱动程序和低分辨率以及刷新率设置的Windows。
- Another consideration in getting the best possible display from your monitor is the screen refresh rate. 获得监视器的可能最佳显示效果的另一个注意事项是屏幕刷新频率。
- Improvements to photo quality (less noise in dark photos, improved viewfinder refresh rate). 提高了照相质量（夜景下更少的噪点，提高了取景器的刷新率）。
- Fixed a bug that was causing the HUD to not display unless the refresh rate was 0. 固定的一个错误，这是造成住房和城市发展部，以不显示，除非刷新率为0。
- The frame refresh rate for NTSC/(PAL) was set at approximately 30/(25) frames/sec. NTSC/（PAL）的帧刷新速率设定为约30/（25）帧/秒。
