您要查找的是不是：
- Quick closing valves, water hammer or supply pressure fluctuations can cause intermittent discharge. 迅速关闭阀门，水锤或供应压力波动可能导致间歇排放。
- quick close valve 速闭阀门
- Close valve completely before installation. 安装前要完全关闭阀门。
- Reconstruction of the Quick Closing Valve of a Feed Water Pump's Driving Steam Turbine 给水泵汽轮机速关阀的分析和改造
- Design of a Hydraulic System for a Three-eccentricity Quick Closing Valve and Simulation of its Dynamic Characteristics 三偏心快关阀的液压系统设计与动态特性仿真
- Equipped with hydraulic check feature to close valve on pressure reversal. 配置液压止回阀来阻止阀门的压力逆向。
- Fuel Oil Quick Closing Valve 速闭阀
- Close valves at both inlet and outlet ends. 进、出水端阀门关上。
- quick closing valve 高速阀,速闭阀
- Where possible, leave the wrench on the valve so a quick closing of the valve can be made in the event of an emergency. 在可能的地方;把扳手留在阀门上;以便在紧急情况下可以迅速的关闭阀门.
- Inflate the Therm-a-Rest mattress by mouth as hard as possible, then quickly close the valve. 用嘴吹气垫使之尽可能膨胀到最坚硬;然后立即关闭阀门.
- Inflate the mattress by mouth as hard as possible, then quickly close the valve. 用嘴吹气垫使之尽可能膨胀到最坚硬;然后立即关闭阀门.
- If cylinder does subcool, close valve and allow cylinder to warm up.DONOT APPLY HEAT! 如果钢瓶没有过冷，关闭阀门让钢瓶升温。
- Equipped with mechanical lift check feature to close valve the moment flow stops, preventing reverse flow. 配置机械提升式止回阀，当阀门出现流量停止时关闭阀门，防止倒流。
- Close valve C. Open valve A, then open valve B 1.2 turn, loosen hose at test cock #4 to remove air. Retighten hose. 关闭阀门C。开启阀门A，然后将阀门B开启1.;2圈，松开测试旋塞4号上的软管排出空气。重新紧固软管。
- Hinge? designed to withstand the shock load of quick closing to insure longer life and continued shut-off. 铰链-能够承受迅速关闭而产生的冲击负载，确保使用寿命更长和连续关闭。
- The electrical connection to the filter is done by a quick closing multipole plug. 与过滤器的电子连接由一个快的关闭的多极的插座完成。
- Mark, the furthest behind, notices the huge dog quickly closing in. 马克，落在最后，发现了后面快速逼迫而来的大狗。
- I quickly closed my eyes and appeared to be meditating. 我赶快闭上眼睛，装作一副在冥想的样子。
- Close valve fully three times for three seconds and record highest pressure indicated each timAll three readings must be above pump relief pressure specifications and within 345 kPa (50 psi) of each other. 紧闭阀门三次，并记录每次的最高压力。三次读数均需高于油泵释压规格，且读数间的差异不得高于345千帕(50 psi)。
