您要查找的是不是：
- This constant defines the port on which the pullup resistor is connected. 这个常量定义了上拉电阻是连接到哪个口的。
- The OUTPUT enable pin (/OE) must be tied high (to VCC) through an external pullup RESISTOR (see Figure 18). 输出使能引脚(/OE)必须通过一个外接的上拉电阻固定到高电位(到VCC)(参见图18)。
- Because the positive side of C1 cannot instantly change its polarity, it pulls low and slowly charges up again through the internal pullup resistor of the input. 而C1的正向不能立即改变极性，其被拉低并通过输入的内部上拉电阻，缓慢的再次充电。
- Omit resistor R3 if IC2 includes built-in pullup resistors, as do many modern microcontrollers. 如果IC2包括内置的上拉电阻，就可以忽略电阻R3，许多现代微处理器都是这样的。
- pullup resistor 正偏电阻
- Some of the students are welding capacitor; the others resistor. 学生中的一些人在焊接电容，另一些人在焊接电阻。
- Why did you pullup these plants? 你为何把这些植物拔起来?
- Remove the resistor from the heater-A/C housing. 从加热器-空调外壳拆卸电阻。
- Salt Bath Started by Salt Slag Resistor. 盐渣电阻启动电极盐浴炉盐渣电阻启动电极盐浴炉。
- Matched resistor sets are available by request. 根据要求,还可提供匹配的电阻。
- The maximum current is set by an external resistor. 整体最大电流取决于外部电阻器。
- A voltage results across the resistor. 这时在电阻器两端产生了一个电压。
- I think there's something wrong with the resistor. 我认为是电阻器出了毛病。
- A discharge resistor connected with terminal block. 有一組放電電阻與端子台接合。
- If you are building a circuit from scratch, and know that you will want a particular resistor to be modelled digitally, you can also achieve this by picking the PULLUP or PULLDOWN models from the component library. 如果是新画一张电路图并且确知所需要的电阻都是数字模型的，您可以从元器件库中的PULLUP或者PULLDOWN库中选择电阻。
- Some of the students are welding capacitor ; the others resistor. 学生中的一些人在焊接电容,另一些人在焊接电阻。
- Resistor offers resistance to the flow of electrical current. 电阻器起着对电流流动的阻碍作用。
- The second resistor has been replaced by a capacitor. 第二个电阻已由一个电容所代替。
- Some of the student is welding capacitor ; the others resistor. 学生中的一些人在焊接电容, 另一些人在焊接电阻。
- The capacitor and resistor should be in the line, it seems pretty. 电阻电容对齐好看,也比较容易布线。
