您要查找的是不是：
- propeller shaft lining 尾轴衬套
- Nothing seems to be wrong with the propeller shaft. 转动轴看来没毛病。
- Reindex propeller shaft 180° and evaluate. 将传动轴翻转180°，并测试。
- Remove the rear propeller shaft. 拆卸后传动轴。
- Fit and inspect shaft line of M/E. 4主机轴系安装报验合格。
- Aligning intermediate shaft and propeller shaft after launching. 下水后中间轴和螺旋桨连接后校中。
- This measurement will give you the propeller shaft angle (C). 测量结果就是传动轴工作角（c）。
- Measuring clearance between propeller shaft &bearing. 螺旋桨轴与轴承间隙测量。
- Different nacelle with deeper ross-section and intake over propeller shaft. 发动机舱、螺旋桨轴处的进气口有一些不同。
- Install the straps and bolts to hold the propeller shaft to the yoke. 安装扣夹和螺栓，将传动轴固定到轴轭上。
- Fracture accidents of vertical shaft lining in aquifer are introduced. 研究了表土段立井井壁的破裂情况；
- In addition, the envelope of ship noise waveform can be remodulated utilizing Hubert transform, and the spectrum components with line rotation frequency of propeller shaft are extracted effectively by bispectrum analysis. 另外，对于通过Hilbert变换解出的舰船辐射噪声包络进行双谱分析，有效地提取出了舰船轴频线谱。
- Align previously made marks on yoke and propeller shaft and install propeller shaft. 将定位轭架上的预制标记对准传动轴并安装传动轴。
- Mark the propeller shaft and pinion yoke, or pinion flange, for installation reference. 在传动轴和传动轴轴轭、或小齿轮轴轭上作标记，作安装的参考标志。
- Align the installation reference marks on the propeller shaft and yoke and install the propeller shaft. 对准传动轴和轭上安装参考标记，安装传递轴。
- Aiming at the deep alluvium support of coal shaft, the composite shaft lining of high strength concrete and double steel cylinders is presented. 针对煤矿立井井筒深厚表土层的支护,提出了采用双层钢板高强混凝土复合井壁结构。
- The upper shaft lining of No.1 blast furnace for smelting high TiO2 bearing vanadic titanomagnetite is repaired by forcing and gunning methods. 对冶炼高钛型钒钛磁铁矿的一号高炉炉身上部进行了压入和喷补造衬。
- The reason the propeller shaft shortens as the angle increases is that the rear axle and differential move in a shorter arc than the propeller shaft. 当角度增加时,传动轴变短的原因是后桥和差速器运动的弧度小于传动轴运动的弧度。
- This accommodates any effective change of length of the propeller shaft as the rear axles move toward or away from the car frame. 当后桥在车架上向前或向上运动时,这种结构足以调整传动轴长度的任何变化。
- Based on the test results, the design method of vertical bearing capacity of the retractable drilling shaft lining was obtained. 由此提出了可缩性钻井井壁竖向承载力的设计方法。
