您要查找的是不是：
- Pressure Drop Model for Two-cone Light Dispersion Hydrocyclones 轻质分散相双锥旋流器的压降模型
- Gas pressure drop model of the rotating packed-bed absorber of closed cycle diesel system 闭式循环柴油机旋转床吸收器气体压降模型
- Presents the theoretical model of pressure drop for flexible duct. 摘要介绍了柔性风管压力损失的理论模型。
- pressure drop model 压降模型
- Watch pressure drop on pressure gauge. 手表压力在压力标准度量上降低。
- Valve exhibits high pressure drop. 阀门出现高压降。
- DID THE PRESSURE DROP TO 0 PSI AND A "NO DRIVE" CONDITION OCCUR? 压力是否降至0PSI而且条件"NO DRIVE"出现?
- However, the pressure drop occurs almost completely in the plug. 然而，压力降几乎完全发生在多孔塞中。
- Drier operates in either flow direction with low pressure drop. 在任何一方向都可操作应用。
- They are commonly used where a minimum pressure drop is important. 通常用在要求压降最小的应用场合。
- A mathematical model was proposed to predict the pressure drop of vibrated fluidized bed based on the physical significance of the pressure drop of the bed. 从振动流化床床层压降的物理意义出发,得出了振动流化床床层压降模型。
- A new model to predict pressure drop due to friction between gas-solid suspension and internal wall in the fully developed region of CFB downers was developed. 结果表明，在下行床的充分发展段，气固两相流与管壁间的摩擦导致表观颗粒浓度显著小于真实颗粒浓度；
- Read the pressure drop across the valve with a Watts Series PG meter. 利用美国瓦茨系列PG仪器读出通过阀门的压降。
- For compressible fluids, where pressure drop exceeds half the inlet pressure. 对于可压缩性流体,如果压降超过进口压力的一半。
- For non-compressible fluids, where pressure drop causes cavitation or flashing. 对于不可压缩性流体,如果压降产生空穴或闪蒸。
- In order to reduce the calculation amount of power flow in large-scale distribution networks, a method of power flow algorithm hybrid model of voltage drop model (VDM) and line losses model (LLM) is presented after analyzing VDM and LLM. 摘要为了减少大规模配电网潮流分析的计算量，在分析了等效电压降落模型法(VDM)和等效线损模型法(LLM)的基础上，提出了二者相混合的配电网潮流算法。
- Calculation data are found in good (agreement) with that of experiment. Comparison is made experimentally with predictions of pressure drop for Venturi scrubber between presented model, modified Calvert model and Yung model. 该模型的理论预测值和实验值一致;并在实验基础上将该模型和修正的Calvert模型及Yung模型进行了对比.
- The performances such as air flow, airside pressure drop, waterside heat exchange and power consumed by compressor vs. frosting time under different condition, were simulated and analyzed by using the ASHPWCH model developed. 采用该模型对机组在不同工况下的性能进行了模拟分析，得到了风量、空气侧压降以及水侧换热器换热量、压缩机的轴功率等随结霜时间的变化。
- The characteristics of pressure drop of wire packing rotating packed bed absorber in air independent propulsion (AIP) system are analyzed under counter-current condition and the model of pressure drop is built. 摘要对不依赖空气动力装置(AIP)系统不锈钢波纹丝网填料旋转床吸收器在气液两相逆流条件下的气相压力降特性进行了分析，建立了压力降预报理论模型。
- Adjust balancing valve until pressure differential gauge reads pressure drop required for desired flow rate gpm. 调整平衡阀直到压差表读出压降符合所要求的流量（加仑/分钟）为止。
