您要查找的是不是：
- Standard version: output shaft with keyway. 标准产品:输出轴带键槽.;消声器可拆除
- Remove the bezel and rubber gasket from the motor output shaft. 从马达输出轴上拆卸玻璃框和橡皮垫圈。
- A formula for calculating power output is derived. 同时推导出输出功率的计算公式。
- Dynamic Torque : the degree, the role of the output shaft torque. 动态扭矩：在分度期间，作用在出力轴上的最大扭矩。
- This results in a decline of power output. 这样的结果是减少了输出功率。
- Peak power output 110 horsepowers. 最大输出功率110马力。
- Stop action : Each output shaft rotation - down a few. 停动数：出力轴每一旋转的停动数。
- Most truck power take offs are arranged so that the vehicle’s clutch disengages not only the main transmission’s output shaft to the drive wheels, but also disengages the PTO. 大多数卡车权力采取平衡的安排，使车辆的离合器分离不仅主传动的输出轴的驱动车轮，而且还脱离接触的动力输出。
- Control of the power output is achieved by varying the fuel supply. 功率输出的控制，是利用改变燃料的供应来实现的。
- The power output of the Deimos has been increased by 40 MW. 戴默斯级的能量栅格输出将增加40MW。
- The power output of the Flycatcher has been increased by 2 MW. 飞燕级的能量栅格输出将增加2MW。
- Rolls-Royce offered CATIC a power output rating for the sets. 罗尔斯-罗伊斯向中航技提供机组的额定输出功率。
- The power output becomes lower and lower by overloading. 功率输出由于过载而越来越低。
- Turn the wiper module over and remove the nut that secures the wiper motor crank arm to the wiper motor output shaft. 转动雨刷模组盖，并拆下将雨刷马达曲柄臂固定于雨刷马达输出轴上的螺帽。
- Output shaft when the swing set in the center of rotation on the trip-down, design may also need to set rotation angles and movements itinerary. 出力轴在摆动时可设定在旋转行程的中心点上停动，也可依设计需要设定旋转角度和升降行程。
- This is the starting point for the analysis of laser power output that follows. 这是下文用来分析激光输出功率的出发点。
- Stop: stop rotating output shaft, cam rollers contact roller cam bearings taper ribbed support of the re-direct. 停止：出力轴停止旋转，凸轮滚子接触滚子轴承式凸轮锥度支撑肋的重直部分。
- High voltage control cabinet for all power outputs. 高压控制柜用于所有功率电输出。
- The clutch rotor is fixed on the input shaft and the clutch armature is fixed on the output shaft. 离合器的转子固定在入力轴，而离合器的电极板与刹车被固定在出力轴上。
- Direct drive to the rolls with heavy-duty helical bevel gears where the output shaft is directly coupled to the roll shaft. 高坚固的螺旋斜线轴承直接驱动辊筒。输出轴直接连接辊轴，中间没有任何传动消耗。
