您要查找的是不是：
- parking brake indicator 停车制动指示器
- parking brake indicator lamp 停止指示器夹
- Adjust parking brake cable tensioner. 调节手煞车钢索拉伸器。
- Adjust parking brake front cable. 调节手煞车前钢索。
- Install parking brake lamp switch. 安装手刹车灯开关。
- Make sure the parking brake is fully set. 确保手刹完全拉上。
- Connect parking brake cable to brackets and lever. 连接到支架和操纵杆的团刹车钢索 。
- He pulls the parking brake lever up. 更清楚了，是拉上那个手刹的“杆”！
- Connect light green lead to parking brake switch lead of car. 连接浅绿色导线到汽车的剎车开关导线。
- Loosen parking brake cable adjustment nut until there is slack in front cable. 放松手刹车钢缆调整螺帽直到前钢缆松弛。
- The parking brake is also electronic and is located on the dashboard. 电子停车制动系统。
- Start the engine, then press the brake pedal and release the parking brake. 发动机点火,然后踩下制动踏板并松手刹。
- If you do drive a car, DO NOT pull the emergency parking brake at a stoplight. 如果你是在驾车行驶的话，在停车等亮的时候不要拉紧急刹车。
- SECURITY. Reverse alarm, neutral start switch, handlever parking brake. 安全性：倒车报警器，空挡开关，手动驻车制动。
- RELEASE THE PARK BRAKE, DISCONNECT THE BRAKE FLUID LEVEL SWITCH CONNECTOR. 放开手煞车，断开煞车油液位高开关接头。
- DISCONNECT THE ABS WARNING LAMP DIODE, LOCATED ABOVE THE PARK BRAKE ASSEMBLY. 断开位于手刹车上方的ABS警示灯二极管。
- Insert front cable through the parking brake lever basInsure the cable retainer is seated into the base. 将前钢缆穿过手刹车拉杆底座。钢缆扣件务必啮合到底座。
- Verify that parking brake cables operate freely and are not binding, or seizeReplace faulty cables, before proceeding. 证实手刹车钢缆操作自由且无约束或卡死。更换故障钢缆后继续。
- Install rotor, caliper, and wheel and tire assembly, then adjust parking brake shoes. 安装转子，夹制器，和车轮和轮胎组合，然后调节手煞车蹄片。
- Engage the parking brake, then disengage it (while holding down the brake pedal). 踩下停车制动踏板,然后放开(不要放开刹车踏板)
