您要查找的是不是：
- non - linear power source 非线性电源
- Why S.M.P.S instead of Linear Power Supply? 为什么采用开关电源代替线性电源?
- Changzhou Starlight Power Source Co., Ltd. 常州市星光电源有限公司。
- Shanghai Future Synergy Power Source Co., Ltd. 上海科力奥电源有限公司。
- All that is needed is a power source. 全部工作所需要的只是一个动力源。
- Average linear power density in the core is 161W/cm. 堆芯平均线功率密度为161W/cm;
- The power source is the weak link in today's portable electronics. 在当前的便携式电子产品中，电源是一个薄弱环节。
- With the tradition cooling system using the linear adjuster, the power source efficiency is very low. 传统散热系统采用线性调整器，电源利用效率很低。
- Use only the type of power source indicated on the printer. 只能使用打印机标签上指定的电源类型。
- Manufacturer of AC power source equipment for testing. 生产检验之用的交流电源设备。
- This power source takes DSP as controller, IPM as its power driver. 该电源采用了DSP作为控制器、IPM作为功率驱动。
- The design of a DC sputtering power source was presented. 介绍一种大功率直流溅射恒流电源的设计。
- Divine power source wine, chemisette desire, pursue of man! 17、英雄本色，神力源酒。
- The traditionary linear power amplifier has been washed out for its low efficiency and big size. 传统的线性功率放大器由于效率低，体积大，因而已经被淘汰。
- Disconnect the CDROM from its power source and the SCSI cabling. 中断 CDROM 的电源与 SCSI 电缆连接。
- In both cases large power sources are required. 在两种情况中都需要大功率的射频源。
- The results show that the maximal linear power and heat flux of MOX-CANFLEX assembly decrease.As a result, the safety margin increases. 结果表明：MOX-CANFLEX组件降低了燃料棒的最大线功率密度和热流密度，从而提高了反应堆运行的安全裕度；
- A linear power amplifier is used, which is mainly made up of an operation amplifier and a Darlington transistor because of the low power range. 由于是处在小功率范围，功率放大器采用的是线性放大器，由一个运算放大器和一个达林顿管构成了功率放大器的主体。
- And it also presents the design method deduced from basic equations of linear compressor, which acts as a power source in the thermoacoustic refrigerator system. 本文设计了一台用以驱动热声制冷机的永磁长动圈式无阀型线性压缩机。
- Designers choose among various power-conversion topologies including linear, switching, and low drop out (LDO) regulators, depending on the requirements for each power source. 根据每个功率源的要求，设计师们选择不同的电源转换拓扑结构，其中包括线性，开关以及低压降稳压器。
