您要查找的是不是：
- Thus, the terminal voltage drops to zero. 这样，路端电压就降到零。
- No load tap ranges should be selected to provide an adequate low-side bus voltage. 无载分接范围选择应能提供正确的低压侧母线电压。
- Consequently, no load current flows through R6 because Q2, whose base-emitter voltage is now 0V, has turned off. 由于Q2的基极-发射极的电压为0V而截止，因此没有负载电流流过R6。
- Typical droop is two cycles in frequency from no load to full load. 从空载到满载转速降一般为两赫兹。
- Invalid static SUBCASE that has no load or enforced displacement. 一般从out文件查找error的位置，都能发现原因。
- A fully charged accumulator has an open circuit terminal voltage of about 6.45v. 蓄电池充满电时，终端的开路电压约为6.;45伏。
- The relation between terminal voltage and terminal current is called a terminal characteristic. 输出端口电压和输出端口电流间的关系称为外特征。
- The continuously acting automatic excitation system to control a generating unit terminal voltage. 控制发电单元机组端电压的连续动作的自动励磁系统。
- Phase difference between the terminal voltage of an alternator and its electromotive force. 交流电机的端电压和其电动势之间的相角差。
- A terminal voltage control system with a generating voltmeter(GVM) for the single ion accelerator was designed. 设计采用旋转伏特计(GVM)控制方式稳定单离子束加速器终端电压。
- protection device against no load voltag 无载电压升高保护器件
- The goernor must hae proision for adjusting speed( generator frequency) and speed droop( no load to full load). 调速器必须具备转速调整（电机频率）降速降调整（负荷到满负荷）能。
- The control principle can improve power angle stability and generators terminal voltage characteristics simul taneously. 控制规律兼顾了改善系统的功角稳定性和发电机端电压特性两方面要求。
- The governor must have provision for adjusting speed( generator frequency) and speed droop( no load to full load). 调速器必须具备转速调整（电机频率）降速降调整（负荷到满负荷）能。
- It indicates the battery terminal voltage when the overdischarge protection started and the fire emergency luminaries can't play the role of emergency. 过放电保护部分启动，消防应急灯具不再起应急作用时电池的端电压。
- The pivot and race surfaces were true surface of revolution and were correctly centred when no load was applied. 轴枢和套圈的表面是准确的旋转表面，并在未施加载荷正确对中。
- Somewhat less obvious is the fact that photodiode leakage and photovoltaic cell internal losses are also functions of terminal voltage. 此外，光电二极管的漏电流和光电池的内部损耗也是其端电压的函数。
- No loading without pre-shipment inspection by Veritas. 未经过真实的检查,不得装载。
- The pivot and race surfaces were true surface of revolution and were correctly centered when no load was applied. 轴枢和套圈的表面是准确的旋转表面,并在未施加载荷正确对中。
- The zero crossing signal of the true phase back EMF can be directly obtained from the motor terminal voltage by properly choosing the PWM and switch control strategy. 该方法不需要引出电机中性点,通过选择PWM和导通控制策略,就能直接从电机端电压获得反电势过零点信号。
