您要查找的是不是：
- Consequently, no load current flows through R6 because Q2, whose base-emitter voltage is now 0V, has turned off. 由于Q2的基极-发射极的电压为0V而截止，因此没有负载电流流过R6。
- Typical droop is two cycles in frequency from no load to full load. 从空载到满载转速降一般为两赫兹。
- Supply Current: The current required from the power supply to operate the amplifier with no load and the output at zero. 供电电流,在不加负载和输出为零的条件下,电源流入运放的电流。
- In the MT for prod method, the range of magnetizing current shall be . 触头法磁粉探伤时，磁化电流范围为。
- The overproof reasons of no load loss and current in distribution transformer are analyzed.The measures to solve the problem are presented. 对配电变压器空载损耗和空载电流超标原因进行了分析,提出了解决问题的措施。
- Invalid static SUBCASE that has no load or enforced displacement. 一般从out文件查找error的位置，都能发现原因。
- It features full-range ZVS, zero DC-bias magnetizing current, symmetrical voltage stress, low output current ripple, and better dynamic response. 搭配此方法之不对称半桥转换器具有全范围零电压切换、无直流偏磁问题、整流二极体有相同耐压、较低输出电流涟波以及较佳之动态响应。
- The goernor must hae proision for adjusting speed( generator frequency) and speed droop( no load to full load). 调速器必须具备转速调整（电机频率）降速降调整（负荷到满负荷）能。
- Reducing the total harmonic distortion (THD) of the magnet current in the parallel resonant network is the key technique for the magnet current tracking accuracy. 在并联型怀特电路中，降低磁铁电流的高次谐波含量，即电流总谐波畸变率(THD)是保证磁铁电流跟踪精度的关键所在。
- The governor must have provision for adjusting speed( generator frequency) and speed droop( no load to full load). 调速器必须具备转速调整（电机频率）降速降调整（负荷到满负荷）能。
- Reducing the total harmonic distortion （THD）of the magnet current in the parallel resonant network is the key technique for the magnet current tracking accuracy. 在并联型怀特电路中，降低磁铁电流的高次谐波含量，即电流总谐波畸变率（THD）是保证磁铁电流跟踪精度的关键所在。
- The pivot and race surfaces were true surface of revolution and were correctly centred when no load was applied. 轴枢和套圈的表面是准确的旋转表面，并在未施加载荷正确对中。
- No loading without pre-shipment inspection by Veritas. 未经过真实的检查,不得装载。
- No-load current from magnetizing current (flux generated) and the iron loss currents (caused by iron core loss) component. 空载电流由磁化电流（产生磁通）和铁损电流（由铁芯损耗引起）组成。
- The pivot and race surfaces were true surface of revolution and were correctly centered when no load was applied. 轴枢和套圈的表面是准确的旋转表面,并在未施加载荷正确对中。
- No load fund Money market fund that does not charge a fixed fee commission to investors. 无佣金基金,不收手续费的基金不向投资者收取手续费的货币市场基金。
- Noise level: The noise level of YU series motors operation at no load is lower than the values shown in the Table. 噪声:电动机空载运转时的噪声不超过下表的数值。
- When stabilizer doesn't connect with lamp, standing in no load condition, stabilizer stop working automatically. 当安定器未接灯泡,处于空载状态时,安定器自动停止工作。
- In this system, a switchable shunt resistor was installed on quadrupole to bypass a small percentage of the magnet current, and solid-state relays were used to switch the shunt resistor. 利用该系统可以测量束流位置检测器的电中心相对相邻四极铁磁中心的位置偏移。
- No load tap ranges should be selected to provide an adequate low-side bus voltage. 无载分接范围选择应能提供正确的低压侧母线电压。
