您要查找的是不是：
- The phase jitter of output signal of the PLL( phase locked loop) frequency doubler is analyzed. 定量分析了数字式锁相倍频器输出信号的相位抖动.
- The results play an important role in the design and fabrication of Cherenkov frequency doubler. 这一结果不同于未考虑传输损耗时转换效率所具有的线性性质 ,这对于切伦科夫频率倍频器的研制中参数的优化具有重要的意义
- Experimental Generation of Entangled Lights from Resonating Frequency Doubler[J]. 引用该论文 罗玉;李莹;潘庆;谢常德;彭堃墀.
- Mode locking can be induced not only by loss modulation, but also by phase modulation. 锁模不仅可用损耗调制取得，也可用位相调制来得到。
- In this paper, the building process of mode locking laser pulse is studied from the point of view of synergetics. 该文用协同学的观点研究锁模激光脉冲的建立过程,认为锁模激光脉冲的建立过程是非线性的合作效应或者是自组织现象。
- Pulsewidth Calculation of Active Passive Mode Locking Fiber Ring Soliton Laser and Its Stability Analysis[J]. 引用该论文 曹顺湘;王发强;陈明华;温扬敬;杨祥林.
- The AE lock mode locks the exposure value for precise exposure metering. 自动曝光锁定模式可在精确曝光测定量时锁定曝光值
- To solve the problem of exaggerated angle pulse in the ratio driving and tracing measuring technique in testing in situ for large gears, the programmable dynamic frequency doubler has been developed. 为解决大齿轮在机测量过程中采用比例驱动跟踪测量技术时转角脉冲当量过大的问题，研究开发了可编程动态倍频器。
- Y.Chen, F.X.Kartner, U, Morgner, S.H.Cho, H.A.Haus, E.P.Ippen, and J.G.Fujimoto, “Dispersion-managed mode locking,” J.Opt.Soc.Am.B. 16, 11, 1999-2004 (1999). 谢嘉民“皮秒与飞秒被动锁模钛蓝宝石雷射之脉冲形成动力学理论与实验之研究”国立交通大学光电工程研究所博士论文，1997年9月。
- The double frequency number is selected directly by software.When input pulse width of the frequency doubler changes, output pulse can well trace.The frequency doubler fully meets the needs o... 该倍频器在输入脉冲宽度变化时能很好地动态跟随，倍频数绝对准确，倍频后的脉冲宽度均匀，完全满足了大齿轮在机测量的要求。
- Base on the principle of Kerr lens mode locking and the fact that the coupling between the laser and pump in the crystal varies with the power, the absorber-like equation is derived. 从钛宝石激光器的克尔透镜锁模原理出发,基于晶体内激光和泵浦激光耦合情况随腔内功率变化这一事实,给出了克尔透镜锁模过程中类可饱和吸收体的表达式;
- Research and Design of Ka-band Frequency Doubler Ka波段二倍频器的研究与设计
- The practical structure of die casting mould with the rotational automatic thread demoulding for shell parts, the calculation of mode locking force and the process parameters were presented. 给出了罩壳零件旋转自动脱螺纹压铸模实用结构,锁模力计算和工艺参数,论述了模具工作原理和设计要点。
- This family integrates a variety of unique features such as an LO frequency doubler and divider ,dual low-noise amplifier (LNA) gain settings .chip operate at cellular and PCS frequencies . 该系列产品采用独特的设计，如：本振（LO）倍频器/分频器、两种低噪声放大器（LNA）增益设置。
- loose locking frequency synthesizer 松耦合频率合成器
- frequency generator frequency doubler 频率发生器倍频器
- The preview mode enables the preview of the depth of field for the selected aperture. The AE lock mode locks the exposure value for precise exposure metering. 预景深模式使您能预先在所选光圈下观察到各景象的景深。自动曝光锁定模式也可在精确曝光测定时锁定曝光值。
- mixer-phase lock frequency synthesizer 混频锁相式频率合成器
- The UV pump radiation was obtained through a sum frequency process of the fundamental and the second harmonic of a CW mode locked Nd: YLF laser, where a novel wald off compensation scheme was adopted. 紫外泵浦光由连续波锁模Nd:YLF激光器输出的1053nm基频光与5265nm二倍频光经和频过程得到,和频过程采用了走离补偿新方案。
- mode locking by amplitude modulation 调幅锁模
