您要查找的是不是：
- In this paper, fracture mechanism, position and direction of crack initiation of mixed mode fracture in several ductile materials are tested, and stress distributions of which are analyzed. 摘要应用传统强度理论和细观力学方法对几种韧性材料在复合载荷条件下的断裂机理、启裂位置、开裂方向进行了实验分析和应力场计算。
- Lensile-shear mixed mode fracture 拉剪混合型开裂
- A Research on Mixed Mode Fracture of Cast Magnesium Alloy 铸镁合金复合型断裂研究
- Finite Element Analysis of Mixed Mode Fracture Dynamic Stress Intensity Factors 型及复合型裂纹动态应力强度因子的有限元分析
- Researches on Criterion of Three-Dimensional Mixed Mode Fracture for Concrete 混凝土三维复合型断裂准则的研究
- NORMAL STRESS INTENSITY FACTOR RATIO CRITERION FOR MIXED MODE FRACTURE OF FIBER COMPOSITES 纤维复合材料复合型断裂正应力强度因子比准则
- Investigation on the Experimental Method for Three-dimensional Mixed Mode Fracture 三维复合型断裂的试验方法探讨
- Keywords Mixed mode fracture;Cavity expansion;Shear fracture;Fracture criterion; 复合型断裂;空穴扩张;剪切断裂;断裂判据;
- DISCUSSION FOR THE POINT OF INITIATION BREAK AND THE DIRECTION OF CRACK GROWTH IN MIXED MODE FRACTURE OF DUCTILE MATERIALS 韧性材料复合型断裂启裂点与开裂方向的讨论
- This is called the mixed mode integrated circuit. 这称为混合型集成电路。
- mixed mode fracture 复合型裂纹
- INFLUENCE OF GEOMETRIC CHARACTERISTICS OF PRE-EXISTING CRACKS ON MIXED MODE FRACTURES UNDER COMPRESSION-SHEAR LOADING 裂纹几何特征对压剪复合断裂的影响分析
- You can run unattended setup for service packs in mixed mode. 不能在混合模式下运行服务包的无人值守安装。
- The group type cannot be changed while the domain is in mixed mode. 在域为混合模式时,组类别不能被更改。
- C. Configure the new instance for Mixed Mode Authentication. 配置这个实例为混合模式验证。
- Keywords: electrorheological fluid, flow mode, mixed mode, shear mode, damper. 关键词：电流变液、流动模式、混合模式、剪切模式、阻尼器。
- Therefore, it is recommended that you switch from mixed mode to native mode. 因此,建议从混合模式切换到纯模式。
- We design a flow mode, mixed mode and shear mode electrorheological dampers. 首先推导其运动方程式及理论模式，进行阻尼器的模拟。
- The results showed that attaked surface had similar appearance like impact fractograph primary failure mechanism of cavitation damage was mixed mode of quasi cleavage and dimple fracture. 观察结果表明 ,其剥落形貌与冲击断口形貌相似 ,剥落机制主要是韧窝和准解理的混合型。
- The double contilever beam (DCB) test,the end notched flexure (ENF) test and the mixed mode bending (MMB) test were conducted to determine the interlaminar fracture toughness and the failure locus in mixed mode for the two composites. 在研究中进行了双悬臂梁（DCB）试验、端边切口（ENF）试验和混合模式弯曲（MMB）试验，以确定此两种复合材料的层间断裂韧性和混合模式断裂曲线。
