您要查找的是不是：
- Experiment indicated that TPX mould was an ideal plastic mould for casting of epoxy resin which was suitably curing at high or middle temperature. 实验表明它是一种适用于高、中温固化环氧树脂浇铸成型的理想的塑料模具。
- A slow flow of metal when under high temperature or great pressure. 蠕变金属在高温或高压下的缓慢流动
- The differences in density may be due to temperature or to salinity. 这种密度的差异源于温度和盐度的差别。
- Key problems on energy saving of high emissivity coating at middle temperature are discussed. 本文论述高发射率涂料在中温下使用,节能的若干关键问题。
- Desulfurization process of a single CaO particle at middle temperature had been calculated using grain model. 本文采用晶粒模型对中温条件下单颗粒石灰石脱硫过程进行数值模拟。
- Back to our running example, we didnt keep checking our body temperature or our feet for blisters while we were out. 回到跑步的例子上。我们在全速奔跑时不会持续检查体温和脚上的水泡。
- The middle temperature TTT-curve may be consisted of several C-curves to form several bays. 由C曲线组成中温TTT图，能形成几个海湾。
- A small change in temperature or humidity can bring about an abrupt change in the growth pattern of snowflakes. 即使气温或水份子饱和度出现微小的改变,雪花生长的图案也可能有很明显的改变。
- As the case may be, either temperature or pressure is to be increased for the process. 对这一过程,或升温或加压视情况而定。
- In general we can have temperature or flux boundary conditions but in this case we will only consider the former. 一般说，边界条件可以是给定温度，也可是给定热流，但这里我们只考虑前者。
- This paper focused on describing planning research of power generation from middle temperature flue gas waste heat in Jiao Zuo cement plant. 本文论述了焦作水泥厂中温烟气余热发电方案研究。
- Illuminant: A body that gives out light of a definite colour temperature or spectral power distribution. 照明体:发出一定色温或光谱强度分布的光的物体。
- The pyrolysis-desorbed hydrocarbon technology introduced in this paper makes this part of hydrocarbons desorbed under low and middle temperature. 本文介绍的热释烃技术，通过在中低温度下热脱的方法解吸硅酸盐矿物中吸留的烃类。
- Fever (or pyrexia): Abnormally high body temperature or a disease characterized by it. 发热:异常升高的体温，或以异常升高的体温为特征的疾病。
- Too high temperature of the operating temperature or chemical gas in the operating ambience will cause hoses cracking. 工作环境温度过高或工作空间有化学气体,可能会导致软管龟裂。
- The interface between air masses of different temperatures or densities. 锋面不同温度、密度的两大气团交界处
- In addition, the notch sensitivity caused by the low ductility at middle temperature and the brittle tendency after long tirne service also may result in frac-ture of disk rim. 此外,中温低塑性所引起的缺口敏感性及长期使用后轮缘部位的脆化倾向也会导致涡轮盘发生轮线断裂。
- When the Al-Mnalloys is crept cyclically at the middle temperature ,the periodic strain abruptly appears in a certain temperature and stress ranges referred to Mg contents. 指出：中温循环蠕变时，铝镁合金有周期性应变突发出现，且在一定温度和应力范围内，其温度范围与镁含量有关。
- The production of low temperatures or the study of low-temperature phenomena. 低温的产品或研究低温现象。
- In order to meet the demand of the heat-resistant encapsulation adhesive curing at middle temperature,a kind of new encapsulation adhesive was researched. 为满足灌封胶黏剂中温固化耐高温的要求,研制新型耐高温灌封胶黏剂体系是十分重要的。
