您要查找的是不是：
- microprogram address bus 微程序地址总线
- Can check ADDRESS BUS or DATA BUS circuit open short or not. 可知ADDRESS BUS或DATA BUS信号本身有无开短路情形。
- The microprocessor uses the address bus to locate data stored in memory. 微处理机使用地址总线设定在存贮器中存贮的数据的地址。
- A memory map is the addressing plan for the address bus bits. 存贮器布局就是地址总线各位的寻址平面图。
- So that the entire DMA transfer address becomes available on the address bus. 以使整个DMA传输地址有效。
- Address Bus:Locates data stores in the memory,input port, or output port. 地址总线：确定数据在存储器，输入口或输出口中的存储位置。
- A memory address consists of binary data being output on an appropriate bus which we call the address bus. 一个存储器地址是由输出到适宜的总线上的二进制数据所组成。这个总线我们称为地址总线。
- The system bus is divided into three logical functions; the address bus, the data bus and the control bus. 系统总线的功能在逻辑上被划分为三部分：地址总线、数据总线和控制总线。
- The system bus is divided into three logical functions: the address bus,the data bus and the control bus. 系统总线的功能在逻辑上被划分为三部分：地址总线、数据总线和控制总线。
- microprogram address control instruction 微程序地址控制指令
- The power dissipated by the address bus is the important power dissipation source of the DSP. 地址总线的功耗是DSP功耗的重要来源。
- A 'real' address, the value that must be placed on the system address bus to select a physical memory bank or device. 物理地址：真实的地址，其值必须被置于系统地址总线中用于选择物理存储位置或者设备。
- The address is transmitted to the memory through a set of parallel wires called an address bus. 向存储器传送地址是经过一组为地址总线的并行导线进行的。
- The actual address that is placed on the address bus when accessing a memory location or register. 当访问内存位置或寄存器时,在地址总线上的真实的地址。
- A novel adaptive-offset bus encoding method was presented for reducing the power dissipation of highly capacitive memory address bus. 为了降低大负载地址总线的功耗;提出了一种新的低功耗自适应偏移量总线编码方法.
- The system controlling logic, multiplexing data bus and multiplexing address bus have been designed. The simulations have passed. 完成了系统的控制逻辑、数据总线复用和解码部分的地址复用器的设计，仿真并通过。
- During normal 80X86 operation (AEN=0), latches A and C and the multiplexer (E) provide address bus bits A19-A16 and A7-A0. 在80X86通常的操作情况下，地址总线的第0-7位和第 16-19位由锁存器A，C和多路复用器E提供。
- The address bus is used by the processor to select aspecific memory location or register within a particular peripheral. 地址总线被处理器用来选择在特定外设中的存储器地址或寄存器。
- Phone mode, modem connection status physical address A 'real' address, the value that must be placed on the system address bus to select a physical memory bank or device. 物理地址:真实的地址,其值必须被置于系统地址总线中用于选择物理存储位置或者设备。
- The address bus specifies the memory locations (addresses) for the data transfers. 地址总线为数据传输指明内存位置（地址）。
