您要查找的是不是：
- Set the main switch selector to A (auto). 把主选择开关调至A(自动)。
- No power even when the main switch is turned on. 即使总开关打开了也没有电。
- Switch off the system at the main switch of the tablet press. 压片主开关关闭系统。
- Set the main switch selector to the desired operation. 设置主选择开关在所需的操作状态。
- Set the main switch selector to A (auto) or M (manual). 把主选择开关转到A(自动)或M(手动)
- The jitter of the main switch is less than 1. 5ns(RMS ). Blumlein主开关工作电压大于280kV;抖动小于1.;5ns(均方根值)。
- MCCB &MCB can be equipped for main switch and sub switch. 箱内可装主进线塑壳开关及分回路微断开关。
- The heater is now ready for operation and the main switch can be closed. 然后这时热水器可以重新工作,可以重新打开电源开关。
- Set the main switch selector to A and set the mode dial to normal mode. 把主选择开关设置在A（自动）,同时把模式盘设置在普通模式。
- The mains switch is located on the rear cover along with the AC inlet, all the other knobs and jacks are on the front. 电源开关位于后盖一起交流入口，所有其他的旋钮和插孔都在前线。
- The tablet press is switched off at the main switch. 关闭压片主开关。
- Each unit should include a main switch and ammeter with a scale of about 20 ampere capacity. 每一套装置应包括一个主开关和电流表，电流表的刻度范围约20安培。
- Main switch selector: Sets the camera to L (lock: power is turned off), and A (Auto), or M (Manual) operation. 主开关选择器:设置相机在L(锁定:电源断开),A(自动)或M(手动)操作。
- When then main switch selector is set to A (auto) or M (manual), the film will resume rewinding. 当主选择开关调至A(自动)或M(手动)时,又会恢复倒片
- The main switch selector, mode dial, up\down buttons, and a brief explanation of their functions are shown below. 以下说明主选择开关、模式盘、向上\\向下按钮以及解释它们的功能。
- To prevent unnecessary battery depletion. Set the main switch selector to L (lock) when you are not using the camera. 为避免不必要的电池耗电,当您不用相机时,请把主选择开关设定到L（锁定）。
- The main switch selector, mode dial, updown buttons, and a brief explanation of their functions are shown below. 以下说明主选择开关、模式盘、向上向下按钮以及解释它们的功能。
- Before disassembling battery and disconnect main switch of the battery, make sure ignition switch has been turned off. 拆卸蓄电池和断开蓄电池主开关之前，确认点火开关已关闭。
- To cancel AE lock before releasing the shutter, press the previewAE lock button again or set the main switch selector to L (lock) to turn off the power. 如要在快门释放前取消自动曝光锁定,请再次按压预景深自动曝光锁定按钮,或把主选择开光调到L,以断开电源。
- The following modes will be canceled when the main switch selector is set to L (lock) AE lock setting (in the previewAE lock user setting mode). Self-timer mode. 当主选择开关设置在（锁定）,以下的模式将被取消。自动曝光锁定设置（在预景深自动曝光锁定设置模式）,自拍模式。
