您要查找的是不是：
- lower plastic limit 塑性下限,下塑限
- It is concluded that the filled soil is silt soil with high liquid limit and plastic limit, which has the low swelling property in natural state. 结果认为，此路基填土为高液限和塑限的淤泥质软土，天然状态下具有弱膨胀性。
- In this paper,a simple method on the plastic limit analysis of annular plates under linearly load has been given out. 本文结合环板在线性荷载作用下的塑性极限分析问题,给出一种简便的计算方法,即奇异函数法。
- Then this paper pointed out that DFC could predict the forming limit of metal sheet with low plasticity well and meantime take the change of forming path into account. 指出利用韧性断裂准则，不但能够较好地预测塑性差的板料成形极限，而且还能考虑应变路径的变化。
- The load when the key layer breaking instantly and strength condition were obtained by the plastic limit analysis method structure. 应用结构塑性极限分析方法，得到了关键层在破断瞬时的载荷并建立了强度条件。
- In the plastic limit analysis,the wrinkler's plate is smartly analyzed in yield-line theory to get the critical compression strength of the coal pillar. 在分析过程中,利用机动法对温克尔地基板(弹簧支撑板)进行了塑性极限分析,得出了煤柱抗压强度的临界值。
- As for simply supported circular plates under linear and uniformly distributed load,This paper calculate the plastic limit load by applying unified strength theory(UST). 对于线性和均布荷载共同作用下的简支圆板,本文采用统一强度理论对其进行了塑性极限分析。
- The rooting percentage of shoot cuttings were more than 90% under ex vitro conditions with peat moss medium in plastic shallow cases arched by a lower plastic film tent to keep a high humidity. 用塑料盘盛装腐苔藓基质,扣塑膜小棚保湿的简易设备进行试管外扦插,生根率达90%25以上。
- This paper discusses the plastic limit load of elbows with local thinn ed area under internal pressure.Fnite element analysis (FEA) and experiments ha ve been used. 采用有限元分析法和试验测定法,对内压作用下局部减薄弯管的极限载荷进行研究。
- The results show that the coatings with good application properties have larger apparent viscosity , higher yield stress , lower plastic viscosity and proper thixotropy at lower shear rate. 实验结果表明,使用性能良好的锭模耐火涂料在低剪切条件下,应具有较大的表现粘度与屈服应力,以及较小的塑性粘度和适当的触变性。
- The paper discusses the plastic limit pressure of elbows with local thinned area on inner wall of extrados.In this research, finite element analysis (FEA) has been used. 摘要采用有限元分析法对内压作用下外拱内壁局部减薄弯管的极限载荷进行研究。
- Note that this method can only be cleaned to the nasal vestibule, and under the nose of the front, inaccessible sinus and upper, middle and lower plastic bottle, can twist open the opening. 注意的是这个方法只能清洗到鼻前庭和下鼻道的前部，不能到达鼻窦和上、中、下塑料瓶的，开口处可以拧开的。
- This paper discusses the plastic limit load of elbows with local thinned area under internal pressure.Fnite element analysis (FEA) and experiments have been used. 摘要采用有限元分析法和试验测定法，对内压作用下局部减薄弯管的极限载荷进行研究。
- It is proved that LMPVC has lower plastication temperature, higher melt fluidity and better compatibility with high molecular mass PVC. 实验表明，这种LMPVC具有较低的塑化温度和较高的熔体流动性，且与高相对分子质量的PVC树脂有良好的相容性。
- An effective procedure for solving the problem of plastic limit analysis of taper-shell with the method of weighted residuals is presented. By this procedure multinomials are used as a test function and subdomain method is applied to eliminate residuals. 本文将加权余量法用于圆锥壳的塑性极限分析,用多项式作试函数,以子域法消除余量,解决了圆锥壳的极限分析问题。
- An analysis method for the connections of prestressed concrete slab to interior column under shear and unbalanced moment is proposed in this paper by applying the plastic limit state theory. 本文采用塑性极限分析方法并利用节点的对称性,建立了预应力混凝土板柱中节点在剪力和不平衡弯矩作用下抗冲切和抗弯的相关方程。
- Experiments and theoretical analysis on the spinning techology of low plasticity double-cone part with curved generatrix were carried out in this paper. 对低塑性材料曲母线双向锥体形状零件的旋压成形工艺进行了大量试验和深入分析；
- In this paper,atterberg limits tests are used to study the influence of added cement dosage on the liquid limit and plastic limit of mucky soil treated with cement. 通过界限含水量试验研究了不同掺量水泥对水泥土液、塑限的影响,利用无侧限抗压强度实验研究了水泥土在饱水养生条件下的强度特性,并得出了一些对工程有益的结论。
- DongYang ShuGuang Hardware plastic limited company Since has been established, in line with " quality first, prestige first " objective. 东阳市曙光五金塑料有限公司自成立以来，本着”质量第一，信誉第一“的宗旨。
- Sherman recommended that Clarke be disciplined, but higher-ups rejected the idea. 谢尔曼建议对克拉克进行纪律惩戒，但高层拒绝了这个意见。
