您要查找的是不是：
- A thin skin or film, such as an organic membrane or a liquid film. 薄皮，薄膜如生物膜或液体膜等细薄的皮或膜
- liquid film pressure 液膜压力
- A thin skin or film,such as an organic membrane or a liquid film. 薄皮，薄膜如生物膜或液体膜等细薄的皮或膜。
- The technique of Squeeze Liquid Film Damping is adopted in precise boring. 在精镗孔加工中采用挤压液膜阻尼技术。
- The film pressure,end leakage flow-rate and frictional coefficient of misaligned journal bearing were calculated. 计算了轴受载变形导致轴颈倾斜情况下,轴承的油膜压力、端泄流量和轴颈摩擦因数等。
- There was obvious offsetting distribution of film pressure and increase of maximum film pressure on this condition. 计算结果表明,此时的轴承油膜压力明显偏布且最大油膜压力增大。
- Liquid film method was researched to recover naphthalene sulfonate from T-acid mother liquor. 采用液膜法回收T酸母液废水中的奈磺酸盐。
- Metal pairs are adhesive together due to asperity peaks penetrating the liquid film. 此时,存在表面微突体的磨损和表面损伤。
- Based on lubrication analysis of journal bearing, the stress distribution of shaft was calculated by using film pressure that calculated as boundary condition of load. 在轴承润滑分析的基础上,将得到的轴承油膜压力作为载荷边界条件,计算了轴的应力分布。
- The results show that there are obvious changes in the film pressure, film thickness and temperature distribution of the journal bearing when journal misalignment appears. 结果表明，轴变形导致轴颈倾斜时，滑动轴承的油膜压力、油膜厚度和温度的分布状况及数值发生了明显变化；
- Based on the low Reynold number and small flux model, the velocity and thickness of the liquid film outside the horizontal tube were studied. 采用低雷诺数、小流量模型对黏性流体在水平管外形成的薄液膜的流速以及膜厚分布进行分析和计算 ;
- For understanding the formational mechanism of gas-lubricated spiral groove bearings pressure fields, the numerical simulations on air film pressure fields are carried out. 摘要为了进一步了解平面螺旋槽气体止推轴承压力场的形成机理，对该种轴承的压力场进行了数值模拟研究。
- Leakage flow rate,liquid film axial stiffness and the ratio of film stiffness to leakage rate of such a seal were compu... 密封环的约束对变形起着重要作用,选择合适的约束可以减小密封面转角,提高液膜刚度,增强密封工作稳定性。
- The results show that there are obvious changes in the film pressure,film thickness and temperature distribution of the journal bearing when journal misalignment appears. 结果表明,轴变形导致轴颈倾斜时,滑动轴承的油膜压力、油膜厚度和温度的分布状况及数值发生了明显变化;
- Foam consists of bubbles, which are very thin liquid films with air inside. 水花含有气泡,气泡其实是外面一片很薄的液体,内里包著空气。
- Consequently, often they are assembled and adjusted, developed are the sputtered Amorphous Thin Film Pressure Sensors with deferent diaphram structures. 对壳体的制造、传感器的装配、调试等做了大量工作，研制出具有 不同弹性敏感元件结构，不同加工方法及不同电路图形的溅射非晶态 薄膜压力传感器。
- It is found that the entraining water flux decreases at first, reaches a minimum, and then increases with the increase of the liquid film velocity. 在两管间隙和气流速度一定的条件下，液膜流速对气流的带液量也存在影响，随着液膜流速的增大带液量先减少后增加。
- In this paper, the operating feature, distribution of gas and forming mechnism of liquid film of Falling film multitubular tower are discussed. 介绍了降膜式多管湿壁塔的操作特点,气体分布和液体成膜的机理。
- Sivakumar, D.;Tropea, C., Splashing impact of a spray onto a liquid film , Physics of Fluids, Vol. 14, no. 12, pp.85-88. 杨鸿进,液滴撞击之实验研究及现象分析,国立台湾大学机械工程研究所硕士论文,2003。
- In addition, attached to the foam membraneana Surfactant molecules on the surface of the liquid film plays a ” “ fix your foam with good stability. 此外，附在泡沫膜上的暗不天活性剂不合子差液膜起着暗不天“拆除”的功用，使泡沫具有精良的安定性。
