您要查找的是不是：
- The observed inlet dimple can be tentatively interpreted by limiting shear stress or wall slippage. 润滑油的极限剪应力特性及其诱发的界面滑移为凹陷产生的原因。
- limiting shear stress 极限剪应力
- Critical resolved shear stress (O’crss). 临界分剪切应力。
- Effect of Shearing Elasticity and Limiting Shearing Stress in the Traction Drive 牵引传动中剪切弹性模量和极限剪切应力的影响
- The interfacial shear stress is a constant proportion of the bottom shear. 交界面的剪力与底部剪力之比是常数。
- The process does not affect the shear stresses. 这样的处理并不影响剪应力。
- According to the twin shear stress theory, this paper improves on Duncan Model. 根据双剪应力理论对邓肯模型进行了修正。
- limiting shearing stress 极限剪切应力
- Clinical Releance: Optimizing axial stability and limiting shear instability appear to be important for creating conditions for timely fracture-healing. 临床关联：轴向稳定性的优化和限制剪切不稳定的出现对适时的骨折愈合创造条件重要。
- Tensile stress and shear stress are transferred by PBL shear connectors. 计算得到钠-混凝土接头的最不利荷载组合内力。
- A fluid is a substance that deforms continuously under an applied shear stress. 液体在剪应力作用下不断变形？？
- The main shear stress and its hydraulic system, calculation and research. 主要对其剪切力和液压系统进行计算和研究。
- Thus fluid shear stress has been considered one of the atherogenic factors. 在动物研究中还发现切应力与内皮细胞增生程度有关。
- With gob span increasing, equivalent shear stress in basic roof increases. 随着采空区跨度的不断增加，基本顶等效剪力不断增大。
- The relationship of steel slippage to shear stress was obtained using a balance limit theory and a pull rod arch model.The loss in normal section bearing capacity as corrosion proceeds is predicted. 运用极限平衡理论和拉杆拱模型求出钢筋滑移量与剪应力的关系，从而建立了不同锈蚀程度的钢筋混凝土梁正截面承载力预计模型。
- Draw the element for maximum shear stress and mark values of all stresses. 画出最大剪应力的单元体并标出全部应力值。
- Friction and cohesion are best defined in terms of the plot of shear stress versus normal stress given in Figure 9. 摩擦角和粘结力最好是根据图9中剪切应力和法向应力的关系曲线确定。
- Cohesion is best defined in terms of the plot of shear stress versus normal stress given in Figure 9. 粘结力最好根据图9中剪切应力和法向应力的关系曲线确定。
- The occurrence of high shear stress at the fibre end is a factor which is expected to lead to crack generation. 在纤维端部存在高切变应力视为导致产生裂缝的因素。
- Oxygen precipitates (useful for gettering) can reduce the yield strength (critical shear stress) up to fivefole. 氧沉淀(可用作吸杂)会使屈服强度(临界剪应力)降低为五分之一。
