您要查找的是不是：
- injection pressure difference 注入压差
- Pressure difference after the dryer. 干燥器前后压差。
- Injection pressure and holding pressure i. 注射压力和保压压力。
- In condition of long-term high production pressure difference, forced injection and forced production are external factors. 长期大生产压差条件下，强注强采是导致储层伤害的外在因素。
- Flow of gas or liquid due to a pressure difference is called viscous flow. 由于压力差引起的气体或液体流称为滞流。
- Injection pressure was 20 pis, 5 sec and power supply was 15kV constant. 自动气压进样;20pis;5sec.
- Install pressure difference display equipments with sound-light alarm. 安装压差显示装置,并有声光报警。
- Repeated injection and production of reservoir fluids had led to the change of pressure difference inside and outside of pores and the change of rock compressibility, porosity and permeability. 油气藏流体反复注采，使得孔隙内外压差不断变化，导致岩石压缩系数、孔隙度、渗透率等物性参数也在不断发生变化。
- Injection pressure of J-ELIII series is different from that of JSW's hydraulic machines. 注塑压力与油压系列不同。
- Pressure differences are indicated on weather maps by isobars. 在气象图上气压差用等压线表示。
- Maximum injection pressure and maximum holding pressure may be restricted due to molding condition. 有的情形下,最大注塑压力,最大保压压力会因成成形条件不同而受到限制。
- The application of a pressure difference across an injector does not cause an immediate velocity response of the liquid propellant. 经过喷注器的压降发生变化时并不马上引起液体推进剂速度变化。
- There should be pressure difference display device when there is a pressure gradient. 有压差梯度的区域无压差显示装置。
- Colon hydrotherapy equipment can sustain a regulated and safe injection pressure to permit cleaning water to reach th extremities of the colon. 大肠水疗法设备能够维持一个规范和安全注射压力,让水清洗,以达到末端结肠。
- Calculate the pressure difference by subtracting the desired outlet pressure from the maximum inlet pressure. 通过从最大进口压力减去所需要的出口压力来计算压差。
- Increased needle injection pressure was obsered as the olume of PMMA increases and as the distribution of PMMA is in close proximity to the cortical walls. 同时，使用的聚甲基丙烯酸甲酯黏合剂的体积的增加还可以增大融合椎体的强度。
- The average pressure difference of SBP in midlife and old folks group and DBP in old folks group all exceeded 5 mm Hg. 中老年组SBP及老年组DBP平均压差均大于5 mm Hg。
- The pH of buffer was 6.2, and the run-voltage was 7kV. Pressure injection model was used and injection pressure was 2406.25 kPa xs. 运行电压为7kV，采用压力进样方式，进样压力为2406.;25kPa×s。
- Find the number on the pressure difference line and note the outlet pressure index number. 找出压差线上的数字，并且注意出口压力指数。
- In the Common Rail accumulator injection system, the generation of the injection pressure is separate from the injection itself. 在共轨蓄压喷射系统，新一代的喷射压力是分开的，从注射本身。
