您要查找的是不是：
- initial electron beam model 初始电子束模型
- To vary(electron velocity) in an electron beam. 调制在一个电子束中改变（电子速率）
- In cathode ray tube display, the continuation of light emission from phosphor after excitation by the electron beam. 在阴极射线管显示器中，用电子束激励后荧光物质光发射的持续现象。
- The basic model about a novel plane yoke and focusing performances when electron beam is making a large angle deflection are discussed. 摘要讨论了新颖的平面形偏转线圈的基本结构模式及其在电子束大角度偏转时所具有的聚焦特性。
- Distributions of initial electron density in UV-preionization TEA CO2 laser[J]. 引用该论文 何宏达;李育德;刘志军;吴建华;陈梅;杨富.
- As the electron beam scans the image, variations of light inten. 当电子束扫描图像时,图像的光强度变化变成了电强度变化。
- Electron Beam Properties and Lasing Experiment of FEL[J]. 引用该论文 杨兴繁;黎明;金晓;黎维华;陈天才;徐勇.
- EB inks is the electron beam energy to curing the WGT. EB油不朱是拔取电子束能量举行固化的兼用油不朱。
- Design of large orbit gyrotron electron beam double-cusp gun[J]. 引用该论文 邹峰;薛谦忠;刘濮鲲.
- Directly employing moving double ellipsoid heat source model in electron beam welding numerical simulation will lead to huge calculation and low efficiency. 直接利用移动双椭球热源模型对电子束焊接过程进行数值模拟时,计算量庞大,计算效率低下。
- Rotary-Gauss body heat source model can show appropriately the character of electron beam deep penetration welding, but only smooth “parabola” shape weld can be obtained. 旋转高斯曲面体热源模型,能较好的反映电子束焊接深熔焊的特点,但只能得到圆滑的“抛物”形焊缝。
- The device in a writing tube or CRT which generates the electron beam. 扫描管或阴极射线管中一种产生电子束的部件。
- The initial electrons are produced by multiphoton ionization and then heated by inverse bremsstrahlung, where the heating rates scale with the square of the laser beam wavelength. 提出了一个“多光子电离引发-逆轫致吸收加热-电子碰撞电离”模型来解释高价离子的产生。
- The combined model with Gauss surface heat source and cylindrical heat source was used according to both the nail-shaped weld and the deep penetration of electron beam welding. 针对电子束焊接特有的钉头状焊缝及其穿透深度大的特点,采用高斯面热源与柱体热源组成的组合热源模型,对焊接温度场进行分析,模拟结果与实际焊缝取得了良好的一致。
- Using normal one beam model, an analytical formula of normal photoelectron diffraction (NPD) I-V curves is derived. 利用垂直单电子束(0,0,束)模型推导了光电子衍射I-V曲线的解析公式。
- The equivalent beam model can reflect the nonlinear characteristics of compressing stiffness with change of loads acting on the damaged mem... 准确地反映了损伤所引起的弯曲与轴向耦合刚度的变化。
- Using methods like electron beam melting or selective laser sintering. 使用方法如电子束熔炼或选择性激光烧结。
- A simply-supported beam model was taken as the numerical analysis exemplification to demonstrate the effect of this damage identification method. 通过一简支梁模型的数值算例，验证了该损伤识别方法的有效性。
- Numerical simulation of a large orbit gyrotron cusp electron beam[J]. 引用该论文 赵青;李宏福;任同;罗勇.
- By introducing damage factor into the model of elastic base beam, the non-elastic base beam model based on damage constitutive relation is proposed. 在弹性基础梁模型的基础上，通过引入一损伤因子，提出一类基于损伤本构的基础梁模型，并在一定条件下对该模型进行了求解和对比分析。
