您要查找的是不是：
- The low density graphite gets higher friction coefficient and bulk worn loss than the high density graphite. 低密度石墨的摩擦系数和体积磨损量比高密度石墨材料高。
- The friction coefficient of the polish surface was 74% of that of grind surface. 摩擦表面抛光处理,使摩擦因数降低为磨削处理时的74%25。
- The experimental results show that EDL has apparent effect on the friction coefficient and streaming potential. 结果表明,外加电场作用下,双电层电粘度效应对摩擦因数具有明显影响;
- The friction coefficient increases with the increase of amplitude, and decreases with the increase of load. 镀层摩擦因数随微动振幅增加而增加,随载荷的增加而减小;
- Dry hair and oiliness hair had little difference on the average friction coefficient. 干性头发和油性头发的摩擦系数相差不大；
- The friction coefficient of sample with high porosity tended to reduce and stabilize in continuous braking cycles. 在连续循环制动时，高孔隙率材料的摩擦系数逐渐降低并趋于稳定。
- Friction coefficient between coated dies and metal samples can be determined by compression tests of ring samples. 使用环形试样压缩试验,可测出涂层模具和相应金属试样间的摩擦因数。
- Experimental results show that POB reduces the friction coefficient and increases the wear resistance of PTFE. 结果表明,添加POB降低了PTFE的摩擦系数,提高了PTFE的耐磨性。
- Lubricating status between surfaces is charaterized with Coulomb friction coefficient. 其中表面间的润滑状态是通过库仑摩擦系数来表征的。
- As for CrN coating, the hard debris results in the increase of friction coefficient and wear rate. CrN镀层磨损产生的硬质磨屑提高了镀层摩擦系数和比磨损率。
- The wear rate and friction coefficient of TPI composites reduced with the GF size decreased. 复合材料的磨损率与摩擦系数随纤维粒径的减小而降低；
- When considering external asperity, friction coefficient decreases with increase of follow deformat and normal force. 考虑表面微凸时，摩擦系数随着变形量的增加，法向压力的增加，摩擦系数呈现下降的趋势；
- The larger friction coefficient and wear rate of GMCs than C/C were observed in wear testing. 它的抗氧化性能明显好于C/C材料;摩擦实验表明,C/C仍是最好的摩擦材料。
- The results show that the friction coefficient of the composite decreases with carbon content increasing. 结果表明,复合材料的摩擦系数均随含碳量的增加呈下降趋势;
- Their friction coefficients slightly increase with wear load up. 随着载荷的增加其摩擦系数略有增加;
- Before friction machine parts inspection, the friction coefficient whether the specimen design requirements, floating steel brush to remove rust, oil, paint cleanse. 配件前检查摩擦机，试件的摩擦系数是否达到设计要求，浮锈用钢丝刷除掉，油污、漆清除干净。
- Objective The friction coefficient between the clasp and enamel was measured as one base of calculating the retention force of clasp quantitatively. 目的 测定卡环与牙面间的静摩擦系数 ,为卡环固位力的定量计算奠定基础。
- The static friction coefficient between the cast Co-Cr alloy clasp and the enamel of human tooth varies within a small range. 常规制作的钴铬合金铸造卡环与牙釉面间的静摩擦系数值变异较小。
- Resistance to deformation and friction coefficient are important parameters for the setting up of control model of continuous rolling process. 摘要变形抗力和摩擦系数是用于设定轧制过程控制模型的重要工艺参数。
- Friction coefficient and wear rate of C(subscript 3D)/MCPA composites under water friction are almost 50 percent of that under dry friction. 水润滑条件下C(下标3D)/MCPA复合材料的摩擦系数和磨损率几乎为干摩擦时的50%25。
