您要查找的是不是：
- Flange clearance required for insertion is given in the bolting chart below. 用于衬垫所要求的法兰间隙请参阅下面的螺栓图表。
- Backflow phenomena in the inlet of inducer and the flange clearance were described.The cause of pressure diffe-rence between suction surface and press surface was explained. 描述了诱导轮进口及轮缘间隙处的回流现象，解释了回流现象发生的原因，即轮缘处叶片压力面和吸力面存在压差；
- Let me tell you some details about clearance. 让我告诉你一些通关的细节。
- flange clearance 轮缘间隙
- Only one set of flange studs is needed. 只需要一套法兰柱头螺栓。
- And, the cooling flow rate of the clearance between stator and rotor as well as the hole of rotor flange was obtained. 获得了静盘与转盘间隙以及转盘外缘小孔的冷气流量。
- These include gusset plates welded to the flange. 这些包括焊接到翼缘上的节点板。
- A loaded pin bears on a hole with small clearance. 一个受载销钉支承于一个具有微小间隙的孔上。
- There is not much clearance here. 这里没有太多空间。
- Using thread or flange capillary connection. 采用螺纹或法兰毛细管联接。
- Press the flange and replace the side sealing ring. 压紧法兰（均匀用力）更换侧密封圈。
- Take the clearance with a feeler. 间隙用塞尺测量。
- There is a clearance of only five inches. 只有五寸的间隙。
- An underpass with a13-foot clearance. 有13英尺净空的高架桥下通道
- Firmly press downward to seat seal on flange. 稳固地向下压将座椅密封压入凸缘中。
- Measuring clearance of rudder jumping stopper. 舵止跳块的间隙测量。
- Measuring installation clearance of rudder bearing. 舵轴承安装间隙测量。
- To create the flange brand is our pursuing. 创法兰品牌是我们的追求。
- Without feel and with flange on the end-shield. 机座带底脚,端盖有凸缘。
- Flange connecting shape shall be square. 法兰连接孔分布需正方形。
