您要查找的是不是：
- electric shrinkage rate 电解膨率
- The technology conditions that have effect on polyester shrinkage rate were discussed. 摘要探讨了影响涤纶短纤维收缩率的工艺条件。
- The results showed that the cool time, iron temperature, bind temperature and bonded fabrics had influences on the heat shrinkage rate of wool fabric. 结果显示，熨烫冷却后的放置时间、熨烫温度、熨烫黏合温度及黏合衬的种类均会影响到毛织物的热缩率。
- The result shows that volume and coverage shrinkage rate of persimmon in sphere cylinder are smaller than in sphere.Drying persimmon in... 计算结果表明,干制后形状呈球台体较球体的体积收缩率和表面积收缩率均小,有利于表观质量的提高。
- The corrosion resistance and freeze/thaw resistance of alkali-activated cement are much better, and the drying shrinkage rate is much greater than ordinary portland cement. 碱?磷渣?粉煤灰胶凝材料的耐蚀性和抗冻性能均显著优于硅酸盐水泥,其干缩比硅酸盐水泥的大。
- The label for the selection of materials, the shrinkage of filmogen in the application scope, and lateral (TD) shrinkage rate higher than vertical shrinkage (MD). 差于采取的标签质料，凡是给求薄膜质料的关上率在使用边界边，并且不竖向(TD)关上率矮于纵向(MD)关上率。
- In addition, it had little influence on the compatibility with superplasticizer, and could reduce the shrinkage rate of mortar, had no dangerous on steel corrosion. 炉渣对水泥的外加剂相容性影响不大，能降低水泥胶砂的干缩率，不会对钢筋锈蚀造成危害；
- From MA content in polymer, drawing temperature and medium, after- chawing process and heat setting temperature, the factors affecting the shrinkage rate of PAN fiber are analyzed. 着重从聚合物中丙烯酸甲酯的含量、热拉伸介质和温度、后拉伸工艺以及热定型温度出发,分析各因素对纤维收缩率的影响,探讨它们与腈纶收缩率之间的内在联系。
- The results indicated that the time of heat preservation had important influence upon the macrostructure, apparent porosity rate, volume weight, the pervasion rate, shrinkage rate and the compressive strength. 研究结果表明，保温时间对孔结构、气孔率与容重、水渗透率、收缩率以及强度有着重要的影响。
- For carbothermal reduction process, a maximum shrinkage rate and a minimum porosity were achieved for the Eu2O3 as the sintering additives and the mechanical properties were the best. 对于碳热还原反应，Eu2O3则具有最大的收缩率和最低的气孔率，所以力学性能最好。
- Surgical and radical resection rates were 94.4% and 85.3% respectively. The shrinkage rate of tumor mass was 79% after pre operative TAC based on CT imaging changes. 本组手术切除率为 94 .;4%25;根治性切除率为 85
- The changes of the shrinkage rates of polyester fabrics in fusible interlining in different temperatures and times are discussed. 取三种粘合衬与涤纶面料粘合,测试不同的粘合温度和放置时间条件下缩率的变化,并且进一步分析了这一变化。
- Using average shrinkage rates of injection-molded parts to decide the dimension of mold cavity can not satisfy the demand of high precision injection-molded parts. 采用一般的平均收缩率方法来确定模具型腔的成型尺寸，已难以满足精密注塑成型制品的精度要求。
- It's quite clear that the electric car is technically feasible. 电动汽车明显在工艺技术上是可行的。
- Industry is a heavy user of electric power. 工业需耗费大量的电力。
- Never poke a finger or scissors into an electric socket. 千万不要把手指或剪刀插进电源插座。
- The machines are driven by electric motors. 这些机器都是由电动机驱动的。
- She buy an electric toaster this morning. 今天上午她买了一个烤面包片的电炉。
- It's a conduit enclosing insulated electric wires. 这是包电线的导管。
