您要查找的是不是：
- The stick of carbon is often used in an electric arc lamp. 碳精棒常用于电弧灯。
- electric arc lamp 电弧灯
- Electric arc with pushing force, stable current. 电弧带推力,电流稳定;
- The arc lamp is very useful in movie shooting, and screening. 弧光灯在电影拍摄和放映的过程中有很大的用处。
- Abstract: The shaped technique of the electric arc tube's shell with neck, which is used in the small power metal-halide lamp, is introduced in this paper. 摘要:超小功率高强度气体放电灯电弧管电极极间距误差要求小，二电极对中要求高，所以采用在电弧管泡壳两端加缩颈来定位电极。
- An unintended electric arc,as between two pieces of apparatus. 飞弧如在两块器械之间产生的一道随意性的电弧
- An unintended electric arc, as between two pieces of apparatus. 飞弧如在两块器械之间产生的一道随意性的电弧
- An electric arc is struck by contacting the electrodes. 接触电极便击出电弧。
- Arc lamps require a current-limiting ballast. 弧光灯需要一个限流镇流器。
- Superior resistance against electric corona and electric arc. 绝缘材料具有优越的耐电晕、抗电弧性能。
- Choice a xenon arc lamp, it uses air-cooled, full-spectrum, 2000W. Recommends replacing lamp every 1500 testing hours. 选用1只美国原装进口风冷式氙灯光源;功率2000W;建议试验时间达1500小时后进行更换.
- Light from a mercury arc lamp will produce fringes over a range of one or two centimeters. 汞灯泡发出的光产生一到二厘米范围以上的条纹。
- The thermal oxidation, photo-oxidation properties of PE-LLD with or without the complex were studied using TG, xenon arc lamp, and IR. 研究表明,该铕配合物对PE-LLD的光氧化过程有明显的阻滞作用,而对其热氧化过程则有加速作用,对材料老化性能总的影响取决于二者的综合。
- Stable electric arc can be ensured from undercurrent to high current. 从小电流到大电流都可以保持稳定电弧。
- Key words：electric arc furnace, lead dust, blood lead, hearing loss. 关键字：电弧炉、铅粉尘、血铅、听力损失。
- Such as electric arc welding, carbon dioxide gas shielded arc welding, TIG etc. 如：电弧焊、二氧化碳气体保护焊、氩弧焊等各种焊接。
- The available ignition circuit for large power xenon short arc lamp is improved to match direct low voltage supply and the new igniter can be used with DC power on board. 为了使大功率短弧氙灯能在低压直流供电的情况下顺利点燃,对现有触发电路进行了改进设计,使其适用于低压直流电源。
- Xenon weather-ometer is a weathering test equipment with xenon arc lamp,but there are not calibration Specifications and measuring instruments in dom estic. 氙灯试验箱是采用氙弧灯光源的气候老化试验设备,国内还没有相应的校准规范及合适的测量仪器。
- The method uses high density infrared (HDI) rapid heating of a plasma arc lamp to liquid phase sinter powder metal compact precursors to a dense structure. 假设电蚀凹孔的轮廓曲线是材料的熔点温度，然后用内差法计算出格点上最后时间的温度，计算出的温度会包含量测误差。
- No colour fade after 300 hours close distant exposure to arc lamps. 以炭精弧光灯近距离照射300小时，油漆没有褪色。
