您要查找的是不是：
- drag force measurement 阻力测量
- Limits the maximum strength of the drag force. 限制拖动的最大强度。
- Adjustment using direct force measurement. 使用直接测力法来调整。
- The drag force decreases as the air density decreases. 当空气密度减小时阻力也减
- Second is article is retarded by the drag force cased by this motion. 一是微粒受到因微粒和流体介质间密度不同而产生的浮力作用；
- Single molecule force spectroscopy (SMFS) is a force measurement based on AFM. 单分子力谱是基于原子力显微镜力的测量方法。
- Using Centrifugal Force Measure Quickly Weighing. 应用离心力测量的快速称重。
- Having derived the fundamental drag force formula, one can derive a number of important parameters. 在导出阻力的基本公式后，就可以得出一系列重要的参数。
- Others posited that dark matter was the culprit: it might exert a gravitational or drag force. 另有些人则断定暗物质才是惹祸的元凶：它可能会对太空船施加重力或阻力。
- The compressed air powered wrench is capable of providing revert-torque to retrievable bolt end and sustain drag force. 该锚杆回收扳手由压气驱动,在给可回收锚杆的尾部提供反扭矩的同时,还可以承受拉力。
- Analvsis of stress and stiffness of the treadling force measurement device by F. E. M. 运动员脚蹬力测定装置的强、刚度分析。
- The difference between the drag force is compared and corrected with the distance between the porous flocs and the solid spheres. 比较污泥胶羽与实心粒子之差异，瞭解其间距离与受力关联。
- Manufactured to fit - accurate and reliable force measurement in extremely difficult environments. 来满足-实现极端困难环境下精确可靠的力测量。
- The drag force ranged 0.01-0.06dynes over Reynolds number of 11-27.These results could be used as the benchmark for floc model development. 在雷诺数11-27间受力范围为0.;01-0
- Thin-film sensors are ideally suited to force measurement in complex geometries. 薄膜传感器是复杂几何形状的结构中测量力度的理想选择。
- A formula for calculating the minimum underbalance in lower permeability reservoir is obtained by applying a drag force function to testing data. 通过将拖曳力函数用于油田测试数据，提出了确定低渗透地层最小测试压差的公式和方法。
- The force measuring unit works on the hydraulic principle. 力测量单元是基于液压原理工作的。
- The door may be supported in a horizontal plane during the pull force measurement test. 在拉力测量期间，可以在水平面内对门进行支承。
- By applying Morison equation and digging force formula the drag force and digging resistant force are obtained and integrated into the virtual model of underwater excavator. 利用Morison方程和挖掘力公式分别推导了水下挖掘设备所受到的水阻力和挖掘阻力,并将其引入水下挖掘机器人的虚拟模型中,对其挖掘过程进行了模拟。
- It can be seen from the results that, as the number of sampling increases, the skewness and kurtosis of the drag force and inertia force tend to converge. 结果表明，随着采样次数的增加，拖曳力和惯性力的偏斜度和峰度驱于收敛。
