您要查找的是不是：
- four throw crank shaft 四弯曲柄轴
- three throw crank shaft 三连曲轴
- Every bike has a serial number near the crank shaft. 每辆自行车在曲柄轴附近都有一个序列号。
- Aligning main engine's crank shaft and intermediate shaft after launching. 下水后主机曲轴和中间轴连接后校中。
- Measuring deflection of crank shaft of M.E. before starting up(after sea trial). 主机动车前（航行试验后）曲轴甩档测量。
- Calculation and field test show that,by using this auxiliary balancing device, both the peak value and the fluctuation of the crank shaft to... 理论计算及现场试验结果表明，该平衡装置具有降低曲柄轴扭矩峰值、减少曲柄轴扭矩波动及降低抽油机耗电等优点。
- Available microwave switch configurations include a simple single-pole double throw (SPDT) switch, multi-position switch, matrix, and cascade. 可用的微波开关配置包括简单的单刀双掷（SPDT）开关、多位置开关、矩阵和级联开关。
- The characters of the electric drive of crank shaft press were studied from the viewpoint of the press working behavior. 从曲柄压力机的工作性质出发,分析了其电力拖动的特点以及电机功率的选择问题。
- The SL version has one function, either undercurrent or undervoltage, with a PDT (single pole double throw) for signal output. SL版具有单功能，在低电流或低电压的情况下，信号输出具有PDT（单极双摆）。
- The authors analyze the motion law of the balancing mechanism,the forces on the counterbalance and the torque on the gearreducer crank shaft. 还对平衡机构的运动规律、平衡块受力及减速箱曲柄轴扭矩等进行了分析。
- A type of series-parallel single pole double throw(SPDT) switch with broadband and high isolation was designed and made up by utilizing several PIN diodes. 采用多个P IN管设计并制作了一种串/并联结构的宽带高隔离度微带单刀双掷(s ing le po le doub le throw;SPDT)开关.
- The warp ends are drawn through heddle eyes in the correct manner and in the turning-over of the crank shaft of the loom, a shed is formed with each turn. 经纱以一定的方式被穿在综丝眼中，通过织机开口机构的驱动上下运动，形成梭口。
- In the thesis, the main research topic is mechanical switch, including SPST (Single Pole Single Throw), SPDT (Single Pole Double Throw) and keyboard switch. 本设计中主要研究的是机械类开关，包括单刀单掷开关和单刀双掷开关及键盘开关。
- Crank shaft,the severe material test will make it hardness and durance. a illtle bit vibration when circulation after balance spindles correction to prolong mechanical life. 曲轴经严格材料测试，坚固且耐用，平衡鎚经精密校正，运转时，震动小。
- All switch contacts shall normally be double-pole double throw (DPDT), Form C, hermetically sealed (when available), rated for 1 ampere minimum at 24VDC. 所有开关触点应通常是双刀双掷（DPDT），C型，（如果可能的话）进行密封，24VDC电压下的额定电流最小为1安培。
- The former causes forced vibration at the circular frequency of the crank shaft and the latter causes transient vibration at the natural frequency of the press. 惯性力激发的振动是以曲轴转速为频率的强迫振动，加工力激发的是以压机固有频率为频率的过渡振动。
- Contact arrangement available in choice of single pole double throw (SPDT) or single pole single throw (SPST), either normally open (NO) or normally closed (NC). 联络安排，可在选择单极双掷（ SPDT产品技术）或单极单掷（的SPST ） ，无论是通常开放（无）或常闭（ NC ）进行。
- By the analysis of several gas forces in the twin-scroll compressor, the calculation formula of working volume and all different crank shaft angle are derived. 分析了双头涡旋齿涡旋盘所受的各种气体力，提出了在任意曲轴转角下的各种气体力及工作腔容积的计算公式。
- This article has engaged in physical and chemical experiments and analyses of outward appear-nace and microcosmic for nodular cast iron crank shaft of big powerful diesel engine. 对大功率柴油机球墨铸铁曲轴进行了宏观、微观全面的理化检验及分析;
- This paper investigates the impact and noise activated by the turning-key rigid clutch and introduces a mathod to avoid or reduce these defects due to over-rotating of the crank shaft. 本文探讨了单转键式刚性离合器工作时产生冲击及噪音的根源，并介绍了一种防治因曲轴超前旋转而引发的冲击和噪音的方法。
