您要查找的是不是：
- The morphology of the blends and diameter of dispersed phase particles were investigated with SEM By counting the diameter of dispersed-phase particles and comparing with twin-screw extr... 这种自制的小型混合机能够适合试验室中研究高分子合金及复合材料的研究需要，因为它的试验料用量只有几克。
- By scanning electron microscope(SEM),the morphology of rubber particle being dispersed phase in ethylene\| propylene rubber toughening polypropylene blends is researched. 通过电子扫描电镜(SEM),研究了乙丙橡胶增韧聚丙烯共混物中作为分散相的橡胶粒子的形态。
- In this paper a method of particle size measurement introduced into the size and shape measurement of dispersed phase in polymer blend is found feasible. 本文将颗粒大小测定方法引入到高分子共混物的分散相尺寸测定中,验证了这是表征分散相尺寸可行的方法。
- The results showed that the particle size of dispersed phase was near to minimum by adding 3% of compatibilizer,and no significant decrease was achieved by adding more compatibilizer. 结果表明，在增容剂用量约3%25时，分散相的粒径尺寸接近最小值，进一步增加增容剂的用量，粒径尺寸没有明显的变化；
- In this case, the continuous phase is aqueous and the dispersed phase is oil. 就这种情况来说，虽然连续相是水，分散相是油。
- The application and development of polymer blend alloys with laminar dispersed phase were reviewed with 23 refrences. 最后，叙述了永久抗静电层状分散聚合物合金的制备及其应用进展。
- During the initial stages of blending, the dispersed phase forms sheets at first, then breaks into submicron particles. 就国外近期研究内容,介绍了熔融共混过程初期的形态结构发展模式。
- The influence of slab grain size,dimension of second phase particle and metallic purity on the mechanical property of the foils for air-conditions are summarized. 总结了铸锭晶粒度、第二相质点大小和金属纯洁度对空调箔力学性能的影响，介绍了改善铸锭晶粒结构、减小第二相质点尺寸和减少金属夹渣的方法。
- The size, shape and distribution of solid phase particle in semi-solid slurry lie mainly on the formation and evolution of liquid phase during remelting of the alloy. 摘要半固态浆料的固相颗粒尺寸、形态和分布主要取决于熔化过程中液相的形成与演化过程。
- The variation of the operating condition did not change the distributive range magnitude of the dispersed phase droplet. 螺杆转速和挤出机产量的变化对末端分散相液滴直径的分布范围影响不大。
- Methods Nifedipine sustained-released tablets were made with spray-dried solid dispersed phase of NFP and PVP mixed with HPMC. 方法用喷雾干燥法将硝苯地平和聚乙烯吡咯烷酮制成固体分散物,再加入羟丙基甲基纤维素等制得硝苯地平缓释片。
- By adding little amount of SMAH, the blends showed a typical "sea-island" morphology, and the dispersed phase dispersed uniformly, ... 而加入少量SMAH后的合金呈典型的"海-岛"结构,分散相分布均匀,断面呈现大量塑性变形的韧性断裂特征。
- The type of motionless mixer can influence the gas holdup, dispersed phase holdup and mass transfer coefficient on some extent. 对于气体搅拌的萃取过程,静态混合器的型式和规格对传质性能和流体力学性能的影响很大。
- PbO_2-matrix composites containing nano-grade TiO_2 as dispersed phase have been obtained on Ti substrate using nano-composite plating technique and were applied to EOP. 用纳米复合电镀技术制备了TiO_2掺杂的PbO_2电极,并利用该电极电解中性电解液制备臭氧。
- Based on the studying of barrier property of laminar blending HDPE/PA blow moulded containers,research progress of dispersed phase morphology of HDPE/PA blends is summarized. 通过对HDPE/PA层状掺混吹塑容器阻渗性能的研究,综述了HDPE/PA共混物分散相形态的研究进展。
- The results showed that the fibrillating of dispersed phase enhanced with the increase of draw rate, but no visible change in diameter of fibers was observed. 结果表明，随著牵引速度的提高，纤维状分散相所占比例增加，但纤维直径无明显变化；
- Polypropylene(PP) and polyamide 6(PA6) were blended and extruded with a single screw extruder, PA6 being the dispersed phase could form microfibrils in PP matrix. 将聚丙烯(PP)与尼龙6(PA6)共混,在挤出加工中PA6作为分散相可以在PP基体中成纤。
- Abstract: Polypropylene(PP) and polyamide 6(PA6) were blended and extruded with a single screw extruder, PA6 being the dispersed phase could form microfibrils in PP matrix. 文摘:将聚丙烯(PP)与尼龙6(PA6)共混,在挤出加工中PA6作为分散相可以在PP基体中成纤。
- Abstract： A high water absorbent polyacrylic acid was obtained by inverse suspension polymerization in the system of cyclohexane as linked phase and water as dispersed phase. 摘 要： 环己烷为连续相,水为分散相,采用反相悬浮聚合法合成了聚丙烯酸高吸水性树脂。
