您要查找的是不是：
- Tetrazene is stable at temperature up to 75℃. 温度高至75℃时，特屈拉辛是安定的。
- The spheroidizing behaviors of carbides formed from deformation at high temperature in medium chromium cast semi steel had been studied during isothermal spheroidizing process. 对中铬半钢经高温形变后所获得的碳化物在等温球化过程中的球化行为进行了研究。
- deformation at temperature 温度变形
- ASB is the damage reason in the condition of deformation at high speed rate. 可以说，绝热剪切带是材料高速率变形条件下损伤的原因。
- The cast iron horsing is of solid one-piece construction to provide maximum rigidity against deformation at mounting and wear resistance to any operating conditions. 铸铁座为整体座结构,轴承座刚性极好,防止轴承在装配时产生变形,在任何情况下轴承座均持久耐用。
- Mechanism of damage of clay pot for utensil glass melting, such as softening deformation at high temperature, corrosion by molten glass, crack by thermal shock, etc was studied. 摘要对熔化器皿玻璃等的粘土质坩埚使用中的高温软化变形、玻璃液侵蚀、热震开裂等损毁机制进行了分析研究。
- We didn't tell him this was expected due to his deformity at birth. 我们也不告诉他这是因为先天畸形。
- Four material constants of the alloy during plastic deformation at high temperature are derived from the interdependencies of flow stress, strain rate and temperature. 从流变应力、应变速率和变形温度的相关性，得出了该合金高温变形时的四个材料常数。
- Ice melts into water at temperatures above zero degrees Celsius. 温度在零摄氏度以上时，冰会融化为水。
- Weakening stiffness of shear-wall and thickening the slab will enlarge the relative deformation at bottom. On contrast, will minish the whole deformation of the building. 削弱剪力墙的刚度和增加楼板厚度都会加剧底层相对变形，一定程度上减小结构的整体变形。
- First, the damage accumulates at the boundary, then it spreads toward the cements.The damage occurred at temperature increasing. 研究结果表明：混凝土内界面是最薄弱的环节，损伤首先在界面上发生，然后向水泥砂浆中发展；
- Secondly, the calcined powder was send to a pre-heated furnace at temperature 1200 oC for 3 min to obtain the platy alpha alumina powder. (3)在脱硫阶段以快速升温热处理的方式有助于剥层效益的发生。
- At reduced environment the content of As increases from 51.82% at temperature of 1300K to 97.28% at 1600K, while the content of As is only 0.19% in melted oxides. 在还原气氛下;在1300~1600K温度范围内;As在气相的含量由1300K时的51.;82%25升高至1600K时的97
- The paper studies elementally the titanium super plastic deformation at room temperature, including the research work on the rapid compression test,properties,micro-structures etc. 对钛合金室温超塑性行为进行了一些探索研究,其中包括在室温条件下在0。
- Meat begins to break down at temperatures warmer than 5 degrees Celsius. 当温度高于摄氏5度时，肉就会开始分解。
- In this case the oxidation proceeds at temperatures of around 100℃. 此时氧化过程在温度100℃左右进行。
- Thomas' Test assesses for a fixed flexion deformity at the contralateral hip. 托马斯试验评价对侧臀部的固定弯曲变形。
- The strain changing with deformation at various points are tested through the hydro bugling experiments and the deformation laws of the three kinds of shells have been analyzed. 设计了,三种胀形预制壳体结构,包括球瓣式、双锥台式、双锥台加圆柱式结构,并进行了液压胀形实验;
- Because of the thermal deformation at high working temperture,the side losse core and derecting mechanisms of die-casting mould will be blocked during working. 压铸模的工作温度较高,在工作温度时结构的热变形会使侧向抽芯结构和导向机构产生卡滞现象。
- The food should be kept at low temperature. 这种食品应低温保存。
