您要查找的是不是：
- definite resistance value 电阻值的确定
- INSTANT OVERLOAD CAPABILITY; WITHOUT ANNUAL SHIFT ON RESISTANCE VALUE. 耐短时间过负载,阻值长时间变化。
- This will determine the maximum allowable resistance value of the DB resistor. 这将决定制动电阻最大允许值。
- Variance coefficients of BYDV resistance value reduces rapidly when generation added, and BYDV resistance gene purify rapidly. 抗性变异随世代的增加减幅较大，抗病基因纯合较快；
- Test and mark the resistance value of the old elements having been replaced (with voltmeter and ammeter) and distribute them in low temperature area. 换下来的元件重新（用压表、电流表）测标其电阻值，配阻用在低温区。
- Very low residue and few causticity ,with high-surface insulation resistance value , no need to wash it also can reach the excellent ICT test value . 焊接后残留物少，腐蚀性小，具有极高的表面绝缘阻抗值，无需清洗即可达到极佳的ICT测试性能。
- Measure winding insulation resistance, use 500v Megohmmeter, insulation resistance value shall not less than 0.5 under normal temperature. 测量绕组的绝缘电阻;使用500V兆欧表;常温下绝缘电阻值不应低于0.;5;
- The meter then measures the voltage across the resistance through the same set of test leads and computes the resistance value accordingly. 然后仪表通过同一套测试引线来测量电阻两端的电压，并计算出相应的电阻数值。
- The D.C. resistance of each phase is also checked against the calculated resistance value for the stator and for balanced resistance between each phase. 每个相位的直流电阻也经过与定子的设计负载电阻值进行核对,以确认能够在每个相位之间进行平衡。
- Among it the sensing surface of sensor should be established Whetstone Bridge, when the pressure is increased, resistance value of each bridge arm takes place change. 其中传感器感压面有惠斯顿电桥,当增加压力时,电桥各桥臂电阻值发生变化。
- Select resistance values for R1 and R2 such that 20 mA flows through each LED. 为R1和R2选择合适的阻值，使得通过每一个二极体的电流都为20毫安培培。
- I can't say anything definite yet. 我还不能肯定地说什么。
- The airborne electric resistance mapping technique, lies in the conversion of measured airborne electromagnetic field signal into apparent electric resistance value that reflects underground strata through inversion or graticule transformation technique. 摘要航空电阻率填图是通过反演或量板转换技术把测量到的航空电磁场信号换算成反映地下岩层的视电阻率值。
- It's definite (that) he will win. 他肯定会赢。
- In order to keep furnace temperature and the load-bearing uniform of each element,before installation,resistance distribution must be carried out.The resistance value deviation of each group should be below 10%. 为保护温和每支元件的负荷均匀，安装前要对元件进行配阻，每组阻值控制在+/-10%25以下。
- The workers demand a definite answer. 工人们要求一个明确的答复。
- I can not say anything definite yet. 我还不能肯定地说什么。
- Is it definite that they will sign that contract? 他们肯定会签署这份合同吗？
- If the heading element is much damaged or its resistance value increases too much and cannot reach the furnace temperature,it is better to replace the heating elements with mew ones. 若元件损坏较多或阻值增长过大，无法达到所需炉温时最好全部更换新元件。
- He avoided give us a definite answer. 他避免给我们明确的回答。
