您要查找的是不是：
- cooling capacity cooling power 冷却能力
- Suitable for CO2 and YAG large power laser equipments, such as laser cutter etc. with cooling capacity from 8.7KW to 115KW. 适用于以CO2及YAG为激光机工作介质及功率较大的激光加工设备，如激光切割设备，制冷量从8.;7KW至115KW。
- YORK Cooling King air-conditioners also achieved breakthroughs in technological excellence in the cooling capacity. YORK Cooling King冷气机的冷气能量也取获工艺性的突破。
- A split stirling 2-stage plastic cryocooler with a cooling capacity of 0. 364W at 77K is described in the paper. 该文介绍了一种分置式斯特林制冷循环二级无磁制冷机，该机在77K时有0.;364W的制冷量。
- The prototype has achieved no load temperature of 51K and cooling power of 632mw at 80K and the COP is 2.31%. 样机获得的最低制冷温度为51K;88K 制冷温度下的制冷量为632mw、制冷效率为2.;31%25。
- With the rapid development of the infrared focus plane, a 2w of cooling capacity at 80K cryocooler is needed. 红外焦平面技术的迅猛发展,迫切需要制冷量2W、制冷温度80K、寿命30000小时以上的大冷量制冷机。
- The more the cooling capacity of the high temperature evaporator, the higher the COP can be improved. 高温蒸发器制冷量越大，双温压缩／喷射混合蒸气压缩制冷循环的制冷系数的提高幅度越大。
- The test used "Enthalpy Difference Method Setup" shows that the prototype can obtain a cooling power of about 700W and COP 0.31. 焓差试验结果表明设计工况下样机实际制冷功率约为700W;循环COP约为0.;31。
- Also, passing supply air through the floor void improves the cooling capacity of both ceiling and floor. 同样，通过地板间层空间提供通风可以同时提高地板和下层天花板的冷却能力。
- The cooling capacity of an air-conditioner is measured in Btu hr, the higher the Btu hr, the faster the cooling capacity. 冷气机的冷却能量度量是以Btu为单位。越高的Btu单位,其冷却能量就越快。
- The optimal percentage of the mixtures can be found.With this percentage the performance of the cryocooler has been improved.It is useful for increasing the cooling power and COP. 通过调整混合工质的配比，改变工质的物性，使其在混合工质最佳配比下工作，对于改进制冷机的性能，提高制冷量和制冷系数等都是有益处的。
- Yap added that, apart from the breakthrough in its cooling capacity, YORK Cooling King has also many innovative features. 他补充说,除了突破冷却能量之外,YORK Cooling King还有许多的创新特点。
- The cooling capacity and COP increase with increasing the generating and evaporating temperature and decrease with increasing the condensing pressure. 系统的制冷量和性能系数随发生压力的升高而升高,随冷凝压力的升高而降低,随蒸发温度的升高而升高;
- The heating and cooling capacity, and primary energy consumption of the GEHP at different ambient temperature, supply water temperature and engine ... 对机组在不同环境温度、不同出水温度和不同转速下冷热量和一次能耗进行了测试。
- The automotive A/C calorimeter which is introduced from USA is used to test the cooling capacity of A/C for different vehicles.Test is 18 KW. 汽车空调系统性能试验台从美国引进，制冷能力测试范围可达18KW，是目前国内最先进的汽车空调测试系统，可以对轿车、客车、工程车、卡车等各种车用空调系统进行性能检测，提供可靠数据。
- The results computed show that 9 5% of coefficient of performance( COP )AND 6 7% of cooling power at 80 K could be gained,if a mixture pair of 10% nitrogen and 90% helium is used instead of pure helium for the pulse tube refrigeration. 计算结果表明 ,如果用10%25氮与 90%25氦的混合工质对代替纯氦 ,脉管制冷机在 80K温度下的制冷系数和制冷量分别可以提高 9 5%25和 6 7%25。
- He claimed that this model, manufactured locally by OYL industries Bhd, is touted to be the air-conditioner model with the highest cooling capacity in the market. 他称,这个由奥维尔工业制造的产品,是市面上冷却能量最高的冷气机。
- With the lowest refrigeration temperature and the cooling power at 20K, the openings of needle valves have been optimized, respectively. The power cooling curves and the coefficients of performance (COP) for the two cases are compared. 同时实现了压力和温度的计算机数据自动采集系统,分别针对无负荷制冷温度(液氦温区)和20 K温区制冷量优化了各调节阀的开度,并进行了功率曲线以及制冷系数(COP)的比较。
- The results show that ESWAC is feasible. Compared with original air conditioner, average cooling capacity increases by 28.2%, and COP increases by 21.5%. 同原来空调器比较 ;复合空调器制冷量平均增加 2 8.;2%25;性能系数平均增加 2 1
- The experimental result shows that using electronic expansion valve instead of thermal expansion valve , the cooling capacity increases by 11.4%, COP increases 9.6%. 试验表明:使用电子膨胀阀对比使用热力膨胀阀;机组的制冷量提高11.;4%25以上、COP提高9
