您要查找的是不是：
- NCL: No control limit is allowed. 不允许超出控制界限。
- NCL:No control limit is allowed. 不允许超出控制界限.
- NCL：No control limit is allowed. 不允许超出控制界限。
- Variation beyond a control limit is evidence that assignable causes are affecting the process. 管制界线是从制程的资料来计算，不要和规格界线混淆。
- A control chart usually displays a lower control limit (LCL) and an upper control limit (UCL). 注 : 一般而言 , UCL与 LCL 的位置为平均值的正负三个标准差。
- This includes computing and interpreting capability indices, estimating the% failures, control limit calculations, etc. 包括计算和解释过程能力指数、计故障百分率、制限计算等。
- Frequency control limits the number of stations you can tune into. 频率控制限制了你们能调谐进的台站数量。
- This includes computing and interpreting capability indices, estimating the % failures, control limit calculations, etc. 包括计算和解释过程能力指数、估计故障百分率、控制限计算等。
- The statistical theories of hypothesis tests and the quality control limit of multivariate have been used to study the discriminance for drink quality stability. 同时,运用假设检验、多元质量控制界等统计理论研究了质量稳定性的判别方法。
- HACCP control tablet covered critical control points (CCP), evident hazard, critical control limit, monitoring measures, and error correction measures etc. HACCP控制表内容为关键控制点(CCP)、显著危害、关键控制限度、监控措施、纠偏措施等项目；
- There is no industry control limits for Copper and Lead in SnAgCu solder pot. 目前行业中没有用于SnAgCu焊料槽中铜和铅的控制极限。
- The recommended control limits for lead is max 1000 ppm, which is in accordance with the RoHs regulation. 铅的推荐控制极限最大为1000 ppm,该值符合RoHs规范。
- Upper and lower statistical control limits that define the constraints of common cause variations. 统计意义上的上限值和下限值,定义数据变量的容许范围。
- For lead-free wave soldering, what is the recommended control limits for impurities such as lead, copper and silver for good control? 要进行无铅波峰焊接,推荐的铅、铜和银等添加剂的控制限制如何才能获得最佳的控制效果?
- Is there a documented system for controlling limited life materials? 对于有使用寿命的原料是否有一个文件化的控制体系
- Most work with insulation board is indoors and is likely to produce dust concentrations in the atmosphere exceeding the Control Limits. 大部分绝缘板的拆除作业均在室内进行，且产生的环境粉尘浓度很可能超出“控制限度”。
- "Is the microetch rate monitored? Is it under SPC control with calculated control limits and are the charts & actions current? 是否对微蚀率进行监控？其是否有SPC图管控并有正在进行的措施？"
- Industry rarely thrives under government control. 在政府控制之下工业很少会发达。
- Dry stripping of bulk insulation and coatings and work other than minor work with insulating board invariably entail temporarily exceeding Control Limits in the area of the work. 干法剥离整体绝缘层和涂层工作不同于绝缘板的小型作业，其作业区中的污染始终会临时超过控制限度。
- For complex MMVF removal work, particularly where exposures might exceed the statutory control limits, a written Method Statement must be produced before the work starts. 对于复杂的MMVF拆除作业（尤其在暴露可能超出法定控制限度时），必须在开始作业前提出书面的施工方案。
