您要查找的是不是：
- compensated op amps [计] 补偿型运算放大器
- The uncommitted op amp has its noninverting input connected to the GND pin. 闲置(理解，看你的应用场合)放大器反向输入端要接到地上。
- Are you smart enough to figure out how to use a $.30 op amp instead? 你是否足够聪明能知道如何用0.;3美元的运放来代替?
- When inputs to most JFET op amps exceed the common-mode range for the part, the output may reverse polarity. 当大部分JFET运放的输入超过它的共模范围时，输出可能发生极性翻转。
- Use comparators for comparing and op amps for amplifying and don"t even think of mixing the two. 使用比较器来比较，放大器来放大，并且不要想着混淆两者。
- Op amps A1A and A1B convert the photogenerated current into a voltage including only the ac components. 运算放大器A1A和A1B将光产生的电流转换为电压，包括仅有的交流器件。
- In this case, you might want to place bypass capacitors directly on the output of an op amp. 这里，我们通过旁路电容直接在运算放大器的输出端旁路。
- When designing the LPF based on ideal Op Amps,the coupling effects of nonideal Op Amps are omitted, resulting in dissatisfactory performance of LPF. 基于理想运算放大器模型所构建的低通滤波器，未考虑非理想器件参数的影响，所设计出的低通滤波器响应性能并不理想。
- In this dissertation.Some problems needed to be solved on switched-capacitor networks(SCN) such as nonideal op amps are inquired into. 本文对开关电容网络（SCN）中现有的一些问题如运放非理想等进行 了深入的探讨和研究。
- The slew rate of the circuit is determined by the charge pump but not the op amp. 此电路的充电时间是决定于充电帮浦而非传统的放大器。
- CMOS Op amp is reported which has a high common-mode input range and a high output swing. 本文报道了一种具有高共模输入范围和高输出电压摆幅的CMOS运算放大器。
- Active filter design software for lowpass, highpass, bandpass and bandstop electronic filters using resistors, capacitors and op amps. 有源滤波器设计软件的低通，高通，带通和带电子过滤器使用电阻，电容和运算放大器。Provides Butterworth; Chebyshev; Elliptic and Bessel Approximations to order 20; with a variety of circuit choices.;提供巴特沃思，切比雪夫，椭圆和贝塞尔逼近常规第20条，与不同的电路选择。
- The input noise voltage of a quiet op amp is 1nv/sqrt(Hz) but there are plenty available with 20nV/sqrt(Hz). Op amps with bipolar front-ends have lower voltage noise and higher current noise than those with FET front-ends （低噪音运放的输入噪声电压可以达到1nv/sqrt(Hz) ，但是我们大量用到的运放具有20nV/sqrt(Hz)的输入噪音。
- The simulation results show that the designed Op Amp achieves a dc gain of 102 dB with a unity-gain frequency of 822 MHz. 仿真结果表明,所设计运放的直流增益可达102dB,单位增益频率为822MHz;
- The earliest IC op amp OUTPUT stages were NPN emitter followers with NPN current sources or resistive pull-downs, as shown in Figure 1.6. 最初的集成运算放大器的输出级是NPN电流源的NPN放射追随器或通过电阻下拉，如图1.;6所示。
- With a circuit like the one described above, this phenomenon is not usually fatal, but it will change the behavior of the op amp. 像上面描述的电路一样，这种现象通常并不致命，但是会改变运放的表现。
- While all modern op amps have push-pull OUTPUT stages of some sort, many are still asymmetrical, and have a greater slew rate in one direction than the other. 现代运算放大器有某种方式的推挽式的输出级，许多也是不对称的，并且某一方向的压摆率有比其它方向的有更大的倾向。
- It applies a negative bias to the summing junction of voltage regulator Op Amp Z1 to cutback the generator voltage when frequency drops below 50 Hz. 它将一个负的偏置信号输向电压调节器中的运算放大器Z1的总和节点，当频率低于50赫兹时，它能降低发电机电压。
- The heart of the system, op amp A1C, includes photoresistor RPR, which represents the feedback element that determines the gain of the stage. 系统核心放大器A1C，包括光敏电阻RPR，代表决定部分增益的反馈元件。
- An op amp combines with strategically placed zener diodes to yield a process-control circuit that has positive- and negative-going hysteresis bands. 运放结合战略上被放置的齐纳二极管产生一个过程控制电路，电路有正、负向磁滞带。
