您要查找的是不是：
- coating surface lacquer 面涂
- Clean finished top coat surface and start curing. 清洗已完工面层并进行养护。
- Two successful cases showed that a coating accessory system of zinc powder under lacquer + epoxy mid lacquer + acrylic acid polyurethane surface lacquer has good protection performance. 以两个成功的案例说明了锌粉底漆+环氧中间漆+丙烯酸聚氨酯面漆涂装配套体系具有较佳的防护性能。
- Coating surface is disposed by coloured or colourless passivation. 3钝化膜应上色均匀;且应覆盖整个镀层面.
- Right now usable chemistry divides lacquer agent or heat eliminate paint, complete the surface lacquer goes up afresh after rub-up. 此时可用化学除漆剂或加热除去油漆，彻底把表面擦净后重新上漆。
- Avoid wooden floor and many water contact as far as possible; Avoid to use acidity, alkalescent liquid to wipe, lest destroy floor surface lacquer bright and clean degree. 尽量避免木地板与大量的水接触；避免用酸性、碱性液体擦拭，以免破坏地板表面漆的光洁度。
- The details of the changes of functionalties on nitrocellulose coating surfaces and the possible mechanisms ascribed to the photodegradation of nitrocellulose lacquer are also discussed. 有关涂膜表面之化学官能基之变化及可能之劣化反应机构亦于文中详细讨论。
- Any resultant softening or gumming of the coating surface shall indicate a lack of cure. 任何由此引起的软化或是胶质化都表明硬化不彻底。
- Because of stress concentration, coating surface suffered micropit failure and deep delamination. 由于应力集中，涂层表面发生微观点蚀和深层剥落；
- The characteristics of nitrogen release of CRNF were apparently determined by thickness of granule coat, number and diameter of pores on coat surface. 不同控释氮肥品种氮素释放特征的差异与肥料包膜的厚度、膜断面及表面孔隙状况不同有关。
- Rough and half coating surface in lower ammonia and deionized water concentration. 当氨水和去离子水浓度较低时，形成的核壳微球为部分包覆，表面包覆层较粗糙。
- The coating surface must not have the fat, the dust dirty and the loose material, the newly built wall needs fully bone dry. 需上漆的表面要无油脂、尘污和松散物质,新建的墙壁需充分干透。
- Cleaning the dust automatically that remained on the flat panels after sanding ,thus enhancing the quality of coating surface. 自动清除板面因砂光而残留下来之灰尘，从而提高板材涂装质量。
- Method: Osteoblast were isolated from crinial of neogenesis rat and the cell culture on that two coating surface in vitro . 方法:采用SD新生鼠颅骨分离成骨细胞,与制备的2种涂层材料共同体外培养。
- The coating mass results found by GD-OES (integrating from the coating surface to the cross point of Sn and Fe curve) were consistent with those obtained by chemistry. 辉光光谱法与化学法测定样品镀锡量结果对比发现，化学法所得结果与本方法中积分到锡铁曲线交点处的结果一致。
- Check environmental temperature, humidity and coated surface temperature. 测定施工环境的湿度,测定欲涂基面的温度。
- Results of EDAX showed that heat treatment could increase content of O in coating surface, but has little effect on number and width of mio-ocracks. 镀层的EDAX分析表明，热处理使镀层表面氧含量增高，但对镀层微裂纹数量和宽度没有明显影响。
- I got a new coat in that store last week. 上礼拜我在那家店买了一件新外套。
- Several kinds of fillers, i.e., phenol-formaldehyde, alkyd, polyester, polyurethane and poly-vinyl-acetate, were tried to coat surface of wheat straw board (WSB) in this paper. 摘要对麦?人造板表面分别试验了酚醛树脂、醇酸树脂、聚酯树脂、聚氨酯、聚醋酸乙烯酯腻子，涂刮腻子后再喷涂丙烯酸漆，并测定漆膜附著力。
- The thermoelasticity problem for a functionally graded coating bonded to metal substrate due to transient heating on the coating surface isconsidered. 研究了金属基底/功能梯度涂层结构中的动态热应力;
