您要查找的是不是：
- Disc bolting is then tightened in closed position. 然后阀瓣螺栓紧固在关闭位置。
- TURN THE CHOKE LEVER TO THE CLOSE POSITION. 把阻气门推到关闭位置。
- Normally closed position, opens when pressure reaches set-point. 通常处于关闭位置,当压力达到设置点时开启。
- The valve may be padlocked in full open or full closed position. 这种阀门能够挂锁在全开或全闭位置。
- A piece or part,as of furniture,that folds out or down from a closed position. 折页如家具的一块或一部分，可以从合起的位置折出来或折下去
- Lock-out capability in either open or closed position for added safety. 更加安全的、可在开启和关闭位置进行锁定的功能。
- The throttle plate moves toward the closed position as rated speed is reached. 当达到发动机额定转速时，节流板趋于关闭位置。
- Operate grounding switch to closing position. 操作接地开关至合闸位置。
- The adjusting of screw prevents the throttle valve from moving to the fully closed position. 调节螺钉防止节气门运动到全关闭位置。
- Where valves must be locked out for safety reasons, valve can be locked in the open or closed position. 由于安全要求必须将阀门锁住的地方,阀门可以被锁在开启或关闭的位置。
- Remove operating lever. Slide remains open if the earthing switch is in the closed position. 拿开接地开关操作杆,如果接地开关已合上,滑板处于接地开关操作孔底部不上弹;
- Position indicators allow at-a-glance determination of whether valve is in open or closed position. 位置指示器使得操作者能够一眼看出阀门是处于开启还是关闭的位置。
- Valve and pump are electrically interlocked so that power is shut-off when the valve is in near closed position. 阀门和泵是通过电气相互作用,相互影响的,因此当阀门接近关闭位置时,电源将关闭。
- A piece or part, as of furniture, that folds out or down from a closed position. 折页如家具的一块或一部分，可以从合起的位置折出来或折下去
- As the fluid stream slows and reverses, the disc responds by swinging to the closed position. 当流体流速减慢并且逆向流动时，阀瓣反应旋启到关闭位置。
- Leaving the disc in a fully closed position firmly closed also prevents weld spatter from falling directly onto the mating faces of the seat and disc. 保持阀瓣处于完全关闭位置也能够避免焊花直接掉在阀座和阀瓣的连接面上。
- Leaving the valve in a fully closed position helps prevent weld spatter from falling directly onto the mating faces of the seats. 保持阀门处于完全关闭状态，有助于防止焊花飞溅直接落到阀座连接面上。
- Open and close the valve to confirm that the valve indicates 0-0 at the closed position. 开启和关闭阀门,确认阀门指示器在阀门处于关闭状态时显示0-0。
- Spring Return - An actuator using a spring to return the valve to either an open or closed position upon loss of power. 弹簧复位-当动力消失时，执行器采用弹簧将阀门恢复到开启或关闭的位置。
- Travel stop is on back seat in open position and is on yoke stop in full closed position. 在开启状态下行程限位是在上密封，在全闭合状态下行程限位是在支架制动。
