您要查找的是不是：
- cable force measurement 索力测试
- Adjustment using direct force measurement. 使用直接测力法来调整。
- Single molecule force spectroscopy (SMFS) is a force measurement based on AFM. 单分子力谱是基于原子力显微镜力的测量方法。
- Using Centrifugal Force Measure Quickly Weighing. 应用离心力测量的快速称重。
- According to the comparison between those results, conclusions are drew as-followed:(1) In comparison of cable force, the value of the same cable tensile force is range in 5%. 主要结论如下:(1)从拉索张力的计算值对比来看,各个施工阶段下,索力有不同,但索力大小变化范围不大,就同一根拉索而言,索力大小变化在5%25以内;
- Deformation errors of the main girder and the cable tower should be eliminated through adjusting the cable force of all hangers, to get the satisfied force errors. 而对于主梁和索塔的变形误差，则需要进行全桥吊索索力的调整加以消除，以获得令人满意的吊索索力误差。
- Under a typical angle, response values of displacement, cable force and membrane principle stress were listed and some means to control tent structure"s response were suggested. 具体的以某一角度的位移，索内力和膜主应力响应为例，得到了一些响应的规律，给出了控制帐篷膜结构风振的一些有效方法。
- Analvsis of stress and stiffness of the treadling force measurement device by F. E. M. 运动员脚蹬力测定装置的强、刚度分析。
- The first one is form-finding analysis.The aim of this part it is to find a satisfying tensioned surface under the equilibrium between cable force and membrane stress. 第一阶段是找形设计阶段,即满足索膜初始张力平衡条件,同时接近设计者预想的曲面形状的求解过程;
- Manufactured to fit - accurate and reliable force measurement in extremely difficult environments. 来满足-实现极端困难环境下精确可靠的力测量。
- Constructional procedure of the bridge reinforced by changing arch structural system into arch and cable system and the reasonable cable force is also presented. 本文还对该加固方法的施工程序及斜拉索的合理索力进行了论述。
- Thin-film sensors are ideally suited to force measurement in complex geometries. 薄膜传感器是复杂几何形状的结构中测量力度的理想选择。
- Because of its peculianties in design and construction, Gonghe cable-stayed bridge adopts the second stretching method as the cable force controlled method and succeeded at last. 公和斜拉桥因其结构和施工的特点，在施工中采用了“二次张拉到位”的索力控制方法，并最终取得了成功。
- The force measuring unit works on the hydraulic principle. 力测量单元是基于液压原理工作的。
- The door may be supported in a horizontal plane during the pull force measurement test. 在拉力测量期间，可以在水平面内对门进行支承。
- The DAQ(Data Acquisition) system for automobile roadway test based on wheel force measurement, is a kind of important equipment for vehicle test. 以汽车车轮力测量技术为核心的汽车道路试验数据采集系统,是汽车整车试验的重要技术装备。
- Cable tensioning in cable supported bridge structures is a very complex construction technology,the perfect design target of cable force cannot be availably reached if the traditional tensioning technique on experience is used. 索支承桥梁结构的拉索张拉是一项复杂的施工技术,传统基于经验的张拉方法索力无法有效地达到理想的设计目标。
- Objective To evaluate the importance of levator force measurement in the surgery to the selected techniques for treating the acquired blepharoptosis after blepharoplasty. 目的探讨术中提上睑肌肌力的测定在睑成形术后上睑下垂矫正术中的重要性。
- By surrounding the determination of suspension cable force and considering the ways of stiff girder construction,three different ways are provided for calculating the force of suspension cable. 以此编制程序并围绕解析法中成桥线形分析中吊索力的确定,结合施工中加劲梁的架设特点,采用三种不同的近似方法来计算吊索力。
- The Back-Propagation(BP) neural network was proposed to correct the nonlinearity and to optimize the force measurement and calibration of an optical tweezer system. 提出了运用BP神经网络法对光镊力的测量和标定进行非线性修正。
