您要查找的是不是：
- bus servo motor 总线伺服电机
- Remove the AC servo motor from the bracket. 从支架上取下马达。
- Attach the new AC servo motor to the bracket. 装上新马达到支架。
- Exchange the servo motor 2HP in spiral. 螺旋交流伺服马达2HP。
- Feed use of the AC servo motor torque of the motor. 进给部分电机采用交流伺服电机转矩大。
- Mill spindle is used by either inverter or servo motor. 铣床主轴采用变频马达或伺服主轴。
- Field Bus Cable for CC-Link , CAN-BUS, LonWorks, PROFIBUS-DP,PROFIBUS-PA, Foundation Fieldbus, AS-i, DeviceNet, Controller-link, INTERBUS, MELSECNET, Servo Motor Cable, H-PCF. 柔性伺服编码器用屏蔽双绞信号电缆、柔性伺服电机用屏蔽动力电缆。
- Lathe spindle is used by either inverter or servo motor. 车床可采变频主轴或伺服主轴。
- The drive is either a three-phase or a three-phase servo motor. 传动机构可以是三相或三相伺服马达。
- Tighten the N coupling nut on the AC servo motor side temporarily. 临时拧紧马达边的N型连接螺母.
- Slotted on shaft end ,suitable for DC motor and servo motor. 轴头开槽，适用于直流电机，伺服电机。
- Each slide is driven by a separate ballscrew and AC servo motor. 每张幻灯片是由一个单独的滚珠丝杠和交流伺服电机。
- The DC servo motors are controlled with motion controller LM629 and motor drive chip LMD18200 based on Pc104 bus. 在PC1 0 4总线控制下 ;应用运动控制芯片LM62 9和电动机驱动芯片LMD1 82 0 0实现了直流伺服电动机的控制 .
- The newly developed cutting unit is also driven by an own servo motor. 新研发的切割机也由自带的伺服马达来驱动。
- CNC system imported from Taiwan and servo motor imported fro japa are adopted. 一、采用台湾进口电脑控制系统和日本进口伺服电机。
- Feeding system adopts CNC servo motor, bending angle uses CNC control. 采用数控伺服电机进料系统，数控折弯角度控制系统。
- New “X” servo motor, new spindle bearings, new pinion &gear drive in 2007. 2007年配新“X”伺服电机，新主轴轴承，新小齿轮和齿轮驱动。
- New “X” servo motor, new spindle bearings, new pinion & gear drive in 2007. 2007年配新“X”伺服电机,新主轴轴承,新小齿轮和齿轮驱动。
- Standard configuration is sidle frequency conversion motor drive; optional configuration is servo motor drive. 标准配置横行变频马达驱动,可选购横行伺服马达驱动。
- Features: main winding, wire arraying servo motor control PLC interpolation, Chinese touching screen display. 特点：主绕、排线伺服电机控制PLC插补控制，显示中文触摸屏。
