您要查找的是不是：
- If the voltage exceeds a critical limit (breakover voltage), the device switches into conduction. 当电压超过临界极限（即导通电压）时，该元件会导通。
- With increasing magnitude of IG, the forward breakover voltage is reduced, and eventually at IG3, the device will turn on successfully if a minimum current, called a latching current, is maintained. 随着IG幅值的增加，正向导通电压减小。最终在IG3处，只要晶闸管持续流过一个最低电流（即闭锁电流），便可使其导通。
- forward breakover voltage 正向转折电压
- breakover voltage 火花电压
- Its voltage has not been exceeded. 它的电压没有超过。
- Note the polarity of the voltage drop across R. 注意R上电压降的极性。
- In resonance conditions. voltage outputs of the vibration structures are up to 0. 4V, which can breakover double germanium diode adequately in rectification circuit. 该结构在共振条件下将运动信号转换为电压信号输出时;电压可达0.;4V以上;足以开启双锗二极管进行电路整流。
- It is fed into the grid at this voltage. 它是以这种电压馈入电力网。
- The current lags behind the voltage. 电流滞后于电压。
- To apply a small voltage to(a grid). 向栅极加偏压
- That is how voltage is measured. 那就是测量电压的方法。
- Diesel generator voltage characteristic test. 柴油发电机电压特性试验。
- The voltage had been reduced in stages. 电压一直在逐步地降低。
- WITH THE DRB, READ THE INTERMITTENT WIPER VOLTAGE. 用DRB读间歇雨刷电压。
- DOES THE VOLTAGE FLUCTUATE OR DROP OFF? 电压波动或消失?
- MAP sensor input below minimum acceptable voltage. MAP感知器输入低于最小可接受电压。
- High voltage control cabinet for all power outputs. 高压控制柜用于所有功率电输出。
- Voltage distortion and power factor lag. 电压波形失真及功因低落。
- Low voltage rating power device. 低电压启动。
- Thus, the terminal voltage drops to zero. 这样，路端电压就降到零。
