您要查找的是不是：
- When machining tapered roller with through-feed centerless grinding method,guidance face inclination of guide wheel has great influence on working quality. 採用無心貫穿磨削方法加工圓錐滾子外圓,導輪制導面傾角對加工的影響很大,探討了導輪制導面傾角的設計,給出了公式。
- The paper introduces an method of machining longer taper, successfully breaks through the confine ,that length of machining taper is restricted in length of the carriage. 介紹了一種加工長錐度的方法,成功突破了錐面加工長度受小拖板長度限制的要求。
- How to Machine Taper Holes on Wearable Parts with Big Diameters 如何加工大直徑易損件上的錐孔
- The machine must break down at this busy hour. 正忙的時候，機器偏偏又壞了。
- The uses of this machine are manifold. 這台機器有多種用途。
- The new grinding machine passed all tests. 這台新磨床通過了所有的試驗。
- Oil feeds into the machine through this tubing. 油經過這個管子流入機器。
- Did you get a good trade-in on your sewing machine? 你以舊縫紉機折價換新合算嗎？
- You may stop the machine by pushing this button. 按下這個按鈕你就可以關掉這個機器。
- Just press the button and the machine will start. 只要一按電鈕，機器就會開動。
- The machine cast up a big heap of earth. 機器捲起了一大堆泥土。
- The machine feeds back everything you need to know. 這架機器可以把你所需要知道的全部材料再提供出來。
- The machine is used to rip up the documents. 這台機器使用來攪碎舊布並為織出新布提供纖維的。
- Machining taper thread inside graphite electrode with general lathe 在普通車床上加工石墨電極錐度內螺紋的方法
- The machine stops and starts at a touch. 這機器一觸即可停止或開動。
- Correction of Tool Position Point When Machining Taper With EDM 線切割加工錐度時刀位點的修正
- Have oiled the machine, he begin to run it. 他把機器上了油之後便開始開動。
- Oil the moving parts of this machine regularly. 要定期給這部機器的運轉部件上油。
- The machine started up with a roar. 機器一聲轟鳴開動了。
- I pieced out the machine with scrap parts. 我用破銅爛鐵拼成了這台機器。
