您要查找的是不是：
- What's the air gap to start preloading? 平台升離水面多少才開始壓載？
- The installation of an air gap and drain line are recommended. 建議安裝氣隙和排放管道。
- Unlike dc machines, induction machines have uniform air gap. 和直流電動機不同，感應電動機具有均勻的氣隙。
- Remove L shape bracket from one side of air gap drain. 從氣隙排放裝置的一側拆卸L型支架。
- Hang the Air Gap Drain on the body of the relief valve (Fig. 2). 將氣隙排放裝置懸挂在安全閥閥體上（圖2）。
- This would create an air gap to eliminate any possible backflow. 這將產生一個氣隙以消除任何可能的迴流。
- A physical air gap must be maintained between the discharge pipe and the drain or sump. 必須在排放管道和排水溝或污水坑之間配置一個硬體氣隙。
- The discharge should be funneled through a Watts air gap fitting piped to a floor drain. 排放應該成漏斗狀通過美國瓦茨氣隙連接件管道引到地漏上。
- An air gap provides the unobstructed, physical separation between the discharge end of a potable water supply line and an open receiving vessel. 在飲用水供應系統的排放末端和開敞的接受容器之間，氣隙提供不被堵塞的硬體分離。
- The assembly shall also include two resilient seated isolation valves, four top-mounted resilient seated test cocks and an air gap drain fitting. 這種總成應該包括兩個彈性閥座隔離閥，四個頂部安裝彈性閥座測試旋塞和一個氣隙排放接頭。
- Reinstall the elbow into the base of the relief valve to hold the Air Gap Drain in place. 將彎頭安裝在安全閥的底座,將氣隙排放裝置固定住。
- NOTE: The installation of a drain line is recommended. When installing a drain line, an air gap is necessary. 注意:建議安裝排泄管道。安裝排泄管道時,有必要安裝一個氣隙。
- The installation of a drain line is recommended. When installing a drain line, an air gap is necessary. 建議安裝排泄管道。當安裝排泄管道時,需要配置氣隙。
- Push as much of the sensing hose as possible into the air gap drain funnel to prevent over spray. 將儘可能多的感應軟管推到氣隙排放漏斗內，以防止從上面噴濺。
- Therefore, the magnetomotive force in the air gap is essentially proportional to the primary ampereturns squared. 所以，氣隙中的磁動勢實際上與初級安匝數的平方成正比。
- The installation of a Watts air gap with the drain line terminating above a floor drain will handle any normal discharge or nuisance spitting through the relief valve. 安裝帶著排放管道的美國瓦茨氣隙，其排放管道的終端位於地漏的上方，用於處理通過安全閥的任何正常排放或有害噴濺。
- Vent the air gap and drain line from the relief valve in accordance with code requirements. 按照規程的要求，排出安全閥氣隙和排放管道的空氣。
- From the top of the air gap, thread the relief valve hose down and out the slot. 從氣隙頂部,將安全閥軟管螺紋旋下來,並拉出溝槽。
- Also, mechanical backflow preventers and air gaps can be bypassed. 此外，機械式防迴流閥和氣隙可以作為旁路。
- The installation must also allow for adequate drainage from the air gap and the discharge line if needed. 如果需要的話，還必須允許從氣隙和排放管道里有適當的排放。
